UpandOver · Apr 29, 2023

Next front doors, frames blasted and repaired.

UpandOver · Apr 29, 2023

That’s it folks this is where I’m up with the defender. Today’s job is to attach the new skins to the doors

UpandOver · Apr 29, 2023

Door skins bonded and folded, a quick one over with 320DA to key and take and press marks out of the ali then a coat of etch primer (2k max meyor CFE 050)

UpandOver · Apr 29, 2023

So pleased that Landyzone have fixed the issue of adding photos, it was quite difficult to keep the momentum going without posting progress.
That’s it back into sixth gear now !

UpandOver · Apr 29, 2023

I’ll leave them dry for today then give them a coat of 2k Maxi Build Max Meyer primer

miktdish · Apr 29, 2023

Excellent work ....

Disco1BFG · Apr 29, 2023

+1 on the above - excellent work - good to see progress, and +1 on the photo upload thingy - I might even start the project thread I've been threatening now, too :banana:

UpandOver · Apr 30, 2023

Todays mission was to make a start on the upper side panels, glass out it was hammer time!
Then a little filler, sanding, heavy build primer, more sanding, more primer, and more sanding, well that’s one down one to go, glad it’s a 90 and not a 110!

UpandOver · May 2, 2023

After some more fetteling and primer the rear top side panels are ready for paint

UpandOver · May 2, 2023

Next job is to bash the bonnet, hope mrs H doesn’t start reading this thread she might think I’m up to something else in the garage…….

lightning · May 2, 2023

Great work so far on that Defender

adrianhartopp · May 2, 2023

Does make it look like you did all that work in 24hrs!!!

Looking very good though.

UpandOver · May 2, 2023

Change of plan for this evenings man shed shenanigans, wind screen out of the frame, frame sanded and etch primed.

UpandOver · May 2, 2023

adrianhartopp said:
Does make it look like you did all that work in 24hrs!!!

Looking very good though.

I could only wish ! Now that I’m up to date with posting progress the reports should be back to snail pace

UpandOver · May 4, 2023

Bonnet bashing, to be honest its not too bad, in fact its very bloody good! Attacked the underside with a wire cup on the grinder them a flap disk and finally DA. Applied some rust converter and hey presto the underside is ready for primer. Highlighted all the small dings and dents on the outside with a torch and market pen and its ready for a quick 80 grit DA then apply high build primer.

UpandOver · May 4, 2023

bonnet prepared and ready for paint

miktdish · May 5, 2023

good job on the bonnet ....

UpandOver · May 7, 2023

Well some good progress this weekend, bonnet now in primer, then attacked left hand wing. Wasn’t going to pay £200+ quid for the 300tdi headlamp panel so took a gamble and bought the £80 early defender one. After some gentle filing I have managed to copy the correct indicator and side light hole.

UpandOver · May 7, 2023

With summer now looming I better change to sixth gear with this landy and get the gazebo empty of landy bit

UpandOver · May 9, 2023

Wings aside as I’m waiting for a RHS headlamp panel and a LHS outer wing that seem to be in short supply. Third time lucky hope the latest order to RimmerBro comes up trumps.
Not wanting to sit still ive cracked on with the banana shaped back door. Think the previous owner must have tried to knock a fence post over with the spare wheel.

Well-Known Member

Attachments

Well-Known Member

Well-Known Member

Attachments

Well-Known Member

Well-Known Member

Attachments

Guns n Chainsaws

Well-Known Member

Well-Known Member

Attachments

Well-Known Member

Attachments

Well-Known Member

Well-Known Member

Active Member

Well-Known Member

Attachments

Well-Known Member

Well-Known Member

Attachments

Well-Known Member

Guns n Chainsaws

Well-Known Member

Well-Known Member

Attachments

Well-Known Member

Attachments

Similar threads