08mckerp

New Member

• Jul 27, 2010

• #1

2 things. Anyone no where to get a bolt for a 1989 90 pandhard rod / the part number??

Also anyone got any tips on how to get the section of wiring loom inside the chassis leg. dont wanna just cable tie it on the outside as could potentially get ripped off.

Cheers

 

Last edited: Jul 27, 2010

08mckerp

New Member

• Jul 27, 2010

• #2

oh and also a radius arm bolt for the same vehicle. Cheers

 

larrynumber1

New Member

• Jul 27, 2010

• #3

attach small weight to string, stand chassis on end (hassle i know, but not if you have a pulley wheel etc..) and drop and hopefully wiggle its way down to other hole then pull loom back with string!

 

08mckerp

New Member

• Jul 27, 2010

• #4

sadly got no way of doing that.

 

baggyjim

New Member

• Jul 27, 2010

• #5

08mckerp said:

sadly got no way of doing that.

Click to expand...

i used a set of fibre glass rods that i use for work pulling cables pipes etc,very flexible and made job easy. simples

 

08mckerp

New Member

• Jul 29, 2010

• #6

any suggestions on wher to get the parts?? or have the part numbers>?

 

MrJC

Well-Known Member

• Jul 29, 2010

• #7

Can you knock out the bolt and take it to your local hardware store? Just make sure it is 'rated'..... lr series is a good system to search... here is your radius arm bolt result, I think you see what socket fits yours? ..search results for "radius arm bolt" | L. R. Series you should find your panhard bolt on the site

 

bustersbus

Well-Known Member

• Jul 29, 2010

• #8

These any guid tae ye...

Just a wee thought about yer loom... if ye can't get it through with some stiffish wire as a giude, ye could always think about some plastic tubin' / blue water pipe fixed on top of the chassis

 

08mckerp

New Member

• Jul 29, 2010

• #9

cheers. also lookin for the rubber gromets in the chassis that go the wires running from the bulkhead to the rear crossmember go thru. if anyone can suggest sumwhere to get them or what to search from plz help

 

08mckerp

New Member

• Jul 29, 2010

• #10

cheers buster!!

 

bustersbus

Well-Known Member

• Jul 29, 2010

• #11

08mckerp said:

cheers. also lookin for the rubber gromets in the chassis that go the wires running from the bulkhead to the rear crossmember go thru. if anyone can suggest sumwhere to get them or what to search from plz help

Click to expand...

That might be a tricky one mate. When ah replaced me rear loom ah just cut through one side of the grommets and stuck them back in when ah replaced the loom.

08mckerp said:

cheers buster!!

Click to expand...

Ye're welcome

 

08mckerp

New Member

• Jul 29, 2010

• #12

mine were pretty perished and one has split into 2 so cant use it again.