After some advice.

I removed the engine today and it gave me a chance to inspect the clutch. I'm not sure how many miles it has on it, but it doesn't look to be in too bad a shape (see pic below). It isn't quite to the wear indicators yet.

IMG_0436.JPG


The clutch release bearing, on the other hand, sounds like it is chocked full of dirt. Very gritting sounding and needs replacing.

IMG_0434.JPG

Since the engine is out anyways, should I go ahead and swap the clutch as well? To be honest, I wasn't having any issues with the clutch other than being a bit noisy but that is likely down to the bearing.
 
Thanks for the advice. It where I was leaning as well, but since the clutch was in decent shape and wasn't giving me any problems I didn't know if it was a waste.

West Slope Rover, I'm headed out your way soon. I move to Northern California this summer. Shipping the Landy ahead of me this May.
 
Thanks for the advice. It where I was leaning as well, but since the clutch was in decent shape and wasn't giving me any problems I didn't know if it was a waste.

West Slope Rover, I'm headed out your way soon. I move to Northern California this summer. Shipping the Landy ahead of me this May.
It's the best part of California. Where are you going to end up?
 

Similar threads