mats

mats

Member
I got my Def 110 2002 td5 ecu optimized by Stockholm Chip Optimering. It cost 300 £ and in combination with blanking the egr it has become a new engine!!
Fuel down from 11 l / 100 km to 9.5 l / 10km. ( 30 mpg?ish) Nominal effect and torque 155hp 400 Nm.!! One can go on fifth gear in steep highway hills where I had to shift down to 4th gear before. In terrain and low gear one can go on idling over ditches really sneaking on low rev through forest tracks like a ghost.
If you are in doubt to optimize your ecu, don't, just do it! It is obvious original software doesn't make justice to the great td5 engine.
 
put a larger(performance) intercooler too... and then will be 100% perfect...you'll gain at least 10% more power...and protect the engine better
 
And a full bore exhaust so the turbo spins up faster. Diesels dont like or need back pressure like a petrol engine. Ideally you should run with an open pipe straight off the turbo exhaust outlet but apparently its anti social and somewhat illegal?
 
Shifty1962 said:
And a full bore exhaust so the turbo spins up faster. Diesels dont like or need back pressure like a petrol engine. Ideally you should run with an open pipe straight off the turbo exhaust outlet but apparently its anti social and somewhat illegal?
Click to expand...

but can i buy one of these somewhere? ...could you point me in the right direction please...i dont care about the legal side of it:D
 
sierrafery said:
but can i buy one of these somewhere? ...could you point me in the right direction please...i dont care about the legal side of it:D
Click to expand...

they are where ever TD5 parts are sold........... stainless.......... or steel........ or gavalum coated?
 
Thor1950 said:
they are where ever TD5 parts are sold........... stainless.......... or steel........ or gavalum coated?
Click to expand...

i googled out "td5 full bore exhaust" before i asked and didnt find any relevant stuff...do they have other "official" name?
 
sierrafery said:
i googled out "td5 full bore exhaust" before i asked and didnt find any relevant stuff...do they have other "official" name?
Click to expand...

TD5 straight through exhaust. 5 alive, as well as tuner mentioned, craddocks, paddocks , also a larger intercooler is needed to get what you want
 
sierrafery said:
but can i buy one of these somewhere? ...could you point me in the right direction please...i dont care about the legal side of it:D
Click to expand...
Got mine from gary at TD5Alive tuning. Full stainless and very good quality. Sold my old stock stainless exhaust and got 2/3 of the cost for the new one back.
 
Shifty1962 said:
Got mine from gary at TD5Alive tuning. Full stainless and very good quality. Sold my old stock stainless exhaust and got 2/3 of the cost for the new one back.
Click to expand...

good point:)...is it more noisy inside the car now?...and what about the improvement? ...do you have better throttle response or something?
 
No noticable change in cabin noise. Sounds a bit throatier outside but nothing to upset anyone including MOT man. Throttle response is crisp with very little turbo lag. I did fit the exhaust at same time as intercooler and remap so have no direct comparison before and after.
 
I've not regretted it. It sounds good when I'm towing and the engine is having to work for its keep. Not quite as good as a V8 but has that strange 5 pot burble.
 
Shifty1962 said:
I did fit the exhaust at same time as intercooler and remap so have no direct comparison before and after.
Click to expand...

I did the exhaust before the intercooler / remap. The exhaust makes the turbo lag absolutely minimal, the larger intercooler increases the lag slightly. I have a boost box, but haven't taken the boost higher, it's at 1.2 now. I believe that taking it up to 1.4 would reduce the turbo lag again...

A VNT would reduce the lag too, but you're looking at a lot of money then :)
 
That's essentially what they are talking about. It's a straight through pipe that bolts in place of the silencer. weld in pipe... same difference, except you can't unbolt it. :)

I have the pipe, just need to get off my bumm and install it.
 
jabber said:
That's essentially what they are talking about. It's a straight through pipe that bolts in place of the silencer. weld in pipe... same difference, except you can't unbolt it. :)

I have the pipe, just need to get off my bumm and install it.
Click to expand...

thanks :eek::)
 
dattard21 said:
I did the exhaust before the intercooler / remap. The exhaust makes the turbo lag absolutely minimal, the larger intercooler increases the lag slightly. I have a boost box, but haven't taken the boost higher, it's at 1.2 now. I believe that taking it up to 1.4 would reduce the turbo lag again...

A VNT would reduce the lag too, but you're looking at a lot of money then :)
Click to expand...

I did up the boot to 1.4. Really really glad I did :)
 
You must log in or register to reply here.

Similar threads

kiwi_steve
Disco 2 TD5 D2 Superchips 'smokey' chip - can it be tweaked?
2
Replies
30
Views
5K
sierrafery
sierrafery
lightning
Remapping Defender TD5, my experience.
Replies
19
Views
15K
Clive jones
Clive jones
Bushtoy
TD5 gremlins....do they ever stop???
Replies
11
Views
4K
lightning
lightning
M
Td5 misfiring and cutting out problem finally solved!
2
Replies
23
Views
53K
sierrafery
sierrafery