ratty
I'm not special I'm limited edition
I had a 300tdi and a 2.5 n/a from a transit in the back of my previous 110 both at the same time with no ill effects.
Turboman
Mab An Gov
Too true, you could dent the sump or w.h.y.Like ratty i have moved two engines no probs at all,you could put a sheet of plywood down first so as not to scratch the floor
Shifty1962
Well-Known Member
As already mentioned cut a sheet of 18mm plywood to lay on the floor. It spreads any point loads so as you dont put dents in the aluminium floor and you can slide the engine in and out without worrying about any damage. Drain as much oil as you can before loading then strap the engine down good and tight. Take some off cuts of 4x2 to use as packers and try to keep it upright. Weight loading is no problem. I had a pallet of bricks in the back of my 90. Loaded them in one at a time. Dont know what they weighed but the springs were a tad compressed.
90truckcab
Well-Known Member
yer no problem , iv done the same with me 90 , nfact it drives a lot better with some weight in the back
larrynumber1
New Member
Or try sitting the sump in an old tyre, thats how i moved my 200tdi. then I tied across top to ensure it didnt fall over
