P

Prith

Active Member
Was just wondering if its ok to take a 2.5NA engine in the back of my 110. Is the floorboard safe to handle the 300 odd kgs?
 
Prith said:
Was just wondering if its ok to take a 2.5NA engine in the back of my 110. Is the floorboard safe to handle the 300 odd kgs?
Click to expand...

I had a 300tdi and a 2.5 n/a from a transit in the back of my previous 110 both at the same time with no ill effects.
 
I think your concern should lie with whether the motor would be able to take the rigours of transportation in this way
 
cambolt said:
I think your concern should lie with whether the motor would be able to take the rigours of transportation in this way
Click to expand...
;)Too true, you could dent the sump or w.h.y.Like ratty i have moved two engines no probs at all,you could put a sheet of plywood down first so as not to scratch the floor
 
As already mentioned cut a sheet of 18mm plywood to lay on the floor. It spreads any point loads so as you dont put dents in the aluminium floor and you can slide the engine in and out without worrying about any damage. Drain as much oil as you can before loading then strap the engine down good and tight. Take some off cuts of 4x2 to use as packers and try to keep it upright. Weight loading is no problem. I had a pallet of bricks in the back of my 90. Loaded them in one at a time. Dont know what they weighed but the springs were a tad compressed.
 
Thanks guys, will do the plywood and then put the engine in. Need to deliver it to a friend 350 km away.
 
ratty said:
I had a 300tdi and a 2.5 n/a from a transit in the back of my previous 110 both at the same time with no ill effects.
Click to expand...

yer no problem , iv done the same with me 90 , nfact it drives a lot better with some weight in the back
 
Or try sitting the sump in an old tyre, thats how i moved my 200tdi. then I tied across top to ensure it didnt fall over
 
I've carried engines in the back of my 88 - I wasn't worried about the floor 'cos I chocked up the engines where I could with timber blocks to spread the load and stop them moving about.
 
Stig left us tuther week with an engine 2 or 3 gear boxes, couple of tranfer boxes and all sorts of props/drive shafts etc. & he was off to Portuloo
 
You must log in or register to reply here.

Similar threads

D
What loom would be best for my landrover 90 thats now running a 300tdi
Replies
14
Views
1K
deccyb
D
1
What’s it worth?
Replies
9
Views
334
110hicap372
1
C
fair price for a 110 200TDi?
Replies
5
Views
617
captainmish
C
H
Getting a 1897 defender 110
Replies
6
Views
251
Anaconda
A
J
Air filter replacement.
Replies
6
Views
595
JimNm
J