KSLB
Active Member
I have recently purchased a Cobra 29LX EU
And Set it all up but I cannot get the SWR to a level I can actually use it.
I have put a 16amp wire between the base of the mount and the chassis and I can get continuity from the chassis to the base of the mount. I have continuity from the pin in the lead on the cb end to the antenna so can't see an issue there. I have checked the mount separately and no continuity from top to bottom as I would expect and there is continuity from the hole where the pin goes in to the top of the mount.
I am set on UK and cannot get below 3 on any channels.
Any ideas?
And Set it all up but I cannot get the SWR to a level I can actually use it.
I have put a 16amp wire between the base of the mount and the chassis and I can get continuity from the chassis to the base of the mount. I have continuity from the pin in the lead on the cb end to the antenna so can't see an issue there. I have checked the mount separately and no continuity from top to bottom as I would expect and there is continuity from the hole where the pin goes in to the top of the mount.
I am set on UK and cannot get below 3 on any channels.
Any ideas?