Pikey
Dummy Ejection Facilitator..
Yes :search: if ya lucky you'll find pics I've posted,
Get 3no. 2 into 1 Push fit fittings and 2 straight connectors, also PushFit and some 6mm tubing.
Cut the axle breather pipe about 6" from the banjo union and fit a straight connector to each one.
Do same with gearbox and transfer box breathers. Make sure ya cut same length. and fit a 2 into 1 fitting to em then extend it to inside engine bay.
Link up the 2 axle breathers with a 2nd 2 into 1 fitting
Link the 2 pipes you have left into the 3rd 2 into 1 fitting
extend the final single pipe up the side of ya snorkel..
Jobs a good un for less than a tenner..
Get 3no. 2 into 1 Push fit fittings and 2 straight connectors, also PushFit and some 6mm tubing.
Cut the axle breather pipe about 6" from the banjo union and fit a straight connector to each one.
Do same with gearbox and transfer box breathers. Make sure ya cut same length. and fit a 2 into 1 fitting to em then extend it to inside engine bay.
Link up the 2 axle breathers with a 2nd 2 into 1 fitting
Link the 2 pipes you have left into the 3rd 2 into 1 fitting
extend the final single pipe up the side of ya snorkel..
Jobs a good un for less than a tenner..
gozzy
Active Member
i have found a kit, comes with
4 high quality elbow connectors
1 push fit push fit manifold
20 cable ties
20m top quality nylon pipe
2 wading plugs
it that enough? as i only know how to fit the axle breathers, after that i dont know what else needs breathers, so if you could help me out i would appricate it/ pics would be great
4 high quality elbow connectors
1 push fit push fit manifold
20 cable ties
20m top quality nylon pipe
2 wading plugs
it that enough? as i only know how to fit the axle breathers, after that i dont know what else needs breathers, so if you could help me out i would appricate it/ pics would be great
robbh
Crazier than a box of frogs on acid
'Tis the same way i did it except it cost me feck all cos i nicked all the bits from work
