M

Mingus

Active Member
hello,

Replacing turbo core and one of the 4 bolts got its head mangled while removing. Anyone know the size or part number for the bolts?

Ta
 
I'm sure i recall them being M8, I just cut bolts down to size. If you've still got it apart check the thread on the manifold
 
On a 200tdi disco, one bolt at least was a bugger to access, open ended spanner only? It's been 16yrs since I removed mine but I also think they were M8, nowt special, I replaced with stainless bolts.
 
Flossie said:
On a 200tdi disco, one bolt at least was a bugger to access, open ended spanner only? It's been 16yrs since I removed mine but I also think they were M8, nowt special, I replaced with stainless bolts.
Click to expand...
ta, on a 300 tdi you need a 1/2 inch spanner rather than a 13mm to remove which is a bit weird. Good old landrover with their mix of metric and imperial although i guess its Garrets fault.
 
Mingus said:
ta, on a 300 tdi you need a 1/2 inch spanner rather than a 13mm to remove which is a bit weird. Good old landrover with their mix of metric and imperial although i guess its Garrets fault.
Click to expand...
Certainly didn't find that with mine although I did have to grind down one side of my spanner to fit it into the gap. I expected them to be a nightmare to undo but they weren't too bad
 
Mingus said:
ta, on a 300 tdi you need a 1/2 inch spanner rather than a 13mm to remove which is a bit weird. Good old landrover with their mix of metric and imperial although i guess its Garrets fault.
Click to expand...
Pretty sure mine was 1/2 inch too. 300 Tdi
 
You must log in or register to reply here.

Similar threads

Seph98
Turbo Hoses with oil
Replies
7
Views
780
miktdish
miktdish
V
Advice on bolt size
Replies
4
Views
614
Brown
Brown
O
How to get exhaust and turbo off 200tdi
Replies
5
Views
747
dag019
dag019
MollyNomad
Freelander 1 Turbo Removal
Replies
5
Views
637
MollyNomad
MollyNomad
Rusty Bucket
Size of bolt for CV output shaft
Replies
5
Views
614
dag019
dag019