gfromleeds

Well-Known Member

• Oct 12, 2013

• #1

Has anyone got a dead blend motor I could buy cheep?
I only need the spindel that sticks out, as ive been abit rough and snaped it off!!
its the distribution motor if it makes any diferance
I'll of cause send some biccie vouchers in return

 

Last edited: Oct 12, 2013

wammers

No longer with us, RIP

Donater

• Oct 12, 2013

• #2

gfromleeds said:

Has anyone got a dead blend motor I could buy cheep?
I only need the spindel that sticks out, as ive been abit rough and snaped it off!!
its the distribution motor if it makes any diferance
I'll of cause send some biccie vouchers in return

Click to expand...

A bit rough is an understatement, how the hell did you manage that?

 

gfromleeds

Well-Known Member

• Oct 12, 2013

• #3

wammers said:

A bit rough is an understatement, how the hell did you manage that?

Click to expand...

it wasn't lined up with the screw holes so twisted it round expecting the motor to turn
it didn't!!!

 

wammers

No longer with us, RIP

Donater

• Oct 12, 2013

• #4

gfromleeds said:

it wasn't lined up with the screw holes so twisted it round expecting the motor to turn
it didn't!!!

Click to expand...

No it won't, have you seen how much reduction there is to the motor? You have more chance of lifting a Chieftain tank with a piece of 3" X 2" as a fulcrum and a straw as the lever. Someone may have a duffer i have three spares but they are all working units.

 

gfromleeds

Well-Known Member

• Oct 12, 2013

• #5

Yea didnt relise untill I opened to see if its repairable

 

S

sandyt

Well-Known Member

• Oct 12, 2013

• #6

Let me have a look think I may have one you can have

 

wammers

No longer with us, RIP

Donater

• Oct 12, 2013

• #7

gfromleeds said:

Yea didnt relise untill I opened to see if its repairable

Click to expand...

You either have to motor them carefully, I use a 7 volt power supply or strip them and set to neutral by lining up the marks on the gears. In neutral the marks should all line up and the drives flat should be lined up across the long edge of the case nearest to it.

 

gfromleeds

Well-Known Member

• Oct 12, 2013

• #8

sandyt said:

Let me have a look think I may have one you can have

Click to expand...

If you have it'll be a huge help! Realy dont fancy replacing the loom as its a dash off job

 

jacckk

Active Member

• Oct 13, 2013

• #9

If sandyt doesn't have one I've got one I'll send you.

 

wammers

No longer with us, RIP

Donater

• Oct 13, 2013

• #10

gfromleeds said:

If you have it'll be a huge help! Realy dont fancy replacing the loom as its a dash off job

Click to expand...

No it's not just radio surround and Hevac unit. You remove relevant wires from plug and replace with wires from new unit. In the right place of course. Bit fiddly you need a pointed probe to release the pins. Or cut an stagger joint the wires with solder and heat shrink.