K

kapilamuni

Active Member
Hi all,
Is the auto trans oil cooler thermostat for ' overheat 'warning message, a 'Normally Open ' type?
It has two wires coming to it but RAVE shows only one.
I have fitted a 7" fan and want to get a line from this to activate the relay.
Your ideas welcome.
 
kapilamuni said:
Hi all,
Is the auto trans oil cooler thermostat for ' overheat 'warning message, a 'Normally Open ' type?
It has two wires coming to it but RAVE shows only one.
I have fitted a 7" fan and want to get a line from this to activate the relay.
Your ideas welcome.
Click to expand...

Normally open. There are two wires to it, one to pin 1 and one to pin 2. Feed to pin 2, when switch is closed it provides a ground via pin 1 and brings on the overheat warning. The cooling fan has a separate switch and circuit, the over temp warning circuit is not used to switch the fan. For cooling fan circuit look at RAVE 1999 and on diesel A6, last illustration page 16 in that section is cooling fan circuit. A description of it's operation can be found in 1999 and on RAVE Automatic gearbox B7 descriptive text page 2. Your fuse box will have different relay/fuse usage and circuit/fuse usage than those illustrated for MY 1999 and on. .
 
Last edited:
You are correct. That's why I want to have a separate relay to switch ON the fan. Can I use pin 1 wire to get the relay activated? or else I will have to add the thermostat for fan too.
 
kapilamuni said:
You are correct. That's why I want to have a separate relay to switch ON the fan. Can I use pin 1 wire to get the relay activated? or else I will have to add the thermostat for fan too.
Click to expand...

I would not have thought so it may well be a low voltage circuit. That is why Land Rover created a separate circuit. The two switches may also have a different operating temp. Although i can only find one switch part number listed. ESR4330
 
Last edited:
Yes, that would support the triggering of a relay. 3A contact rating at 24V - so will be similar at 12V, and a relay coil will most likely draw well under 100mA, so that would work fine. It's not waterproof though - it's designed to mounted inside a compartment (it's the same style as the EAS compressor uses). I'm sure you could get a version designed to be out in the elements though
 
You must log in or register to reply here.

Similar threads

W
P38 oveheating
2 3 4
Replies
79
Views
6K
Montyjohn
Montyjohn
feyniriel
P38 alarm and immobilizer problems
2 3
Replies
42
Views
2K
Datatek
Datatek
D
Auto box oil cooler pipes
Replies
5
Views
1K
Datatek
Datatek
jimmacD
Back to the P38 house of pain!
2
Replies
21
Views
2K
Grrrrrr
Grrrrrr
M
Mark 1 Freelander TD4 AUTO SPORT
Replies
2
Views
615
damian46
damian46