L

lynall

Well-Known Member

Full Member

• Jan 21, 2021

• #1

Car cut out going round roundabout yesterday, then today it just stopped on its own whilst waiting at the same roundabout!
So little play with ign on a quite road, and the slightest pressure is enough to turn the key back and turn the engine off, so reckon switch has just about had it.
Loads to choose from just the switch or the whole assy, whole assy makes more sense as I am assuming the switch detent is in the main lock itself?
Do not want a cheap shttier that wont last.

 

Last edited: Jan 22, 2021

saxavordian

Well-Known Member

• Jan 21, 2021

• #2

Shame you don't know Jimmy the Dink he's pretty good at hotwiring. The barrel and key normally wear out to a point you cannot turn the engine off. There two parts to the ignition if I remember rightly. one diesel types and petrol version if ordering. and then the key part also has their difference. Worth checking a couple of lr spares websites for the right one.

 

Europa486

Well-Known Member

• Jan 21, 2021

• #3

The standard make should be Lucas, but check and replace with same type,

 

L

Litch

Well-Known Member

• Jan 21, 2021

• #4

I fitted a 300TDi spec Britpart switch / lock to my 90 back in 2014 (to replace the non-locking N/A type fitted as standard) and it has been fine.

 

L

lynall

Well-Known Member

Full Member

• Jan 22, 2021

• #5

Lucas complete assembly off of fleabay 50 quid, thanks for the replies.

 

bankz5152

Well-Known Member

• Jan 22, 2021

• #6

Before swapping the barrel try changing the main live connector on the back of the barrel. That was the issue on mine been fine now for over a year.