Hi Folks
2003 Disco 2 needs primed to start goes perfect for 1/2 mile stops, prime again spin on starter then starts for another 1/2 mile. Things I have done
1. Fitted new pump in tank
2. New filter plus checked valves at pump head (no valve in rear:doh: left)
3. New regulator - gauze to block clear
4. New seals + copper washers to injectors
5. Injector loome + connections to ECU bone dry
6. I have not got a fitting to check pressure at temp sensor but HP
side of pump putting up 8.2 bar at Reg inlet.
Now - all of the above has been discussed on other threads but the only other thing I have discovered is that when the engine dies the pump immediately stops even though the ignition is still on. When I disconnect the black plug to the ECU and reconnect it the pump starts again.
HELP NEEDED (before the tablets run out) :doh::doh::doh:
2003 Disco 2 needs primed to start goes perfect for 1/2 mile stops, prime again spin on starter then starts for another 1/2 mile. Things I have done
1. Fitted new pump in tank
2. New filter plus checked valves at pump head (no valve in rear:doh: left)
3. New regulator - gauze to block clear
4. New seals + copper washers to injectors
5. Injector loome + connections to ECU bone dry
6. I have not got a fitting to check pressure at temp sensor but HP
side of pump putting up 8.2 bar at Reg inlet.
Now - all of the above has been discussed on other threads but the only other thing I have discovered is that when the engine dies the pump immediately stops even though the ignition is still on. When I disconnect the black plug to the ECU and reconnect it the pump starts again.
HELP NEEDED (before the tablets run out) :doh::doh::doh: