Evening all,
Just after a bit of advice and what people think my disco is worth (1994 300 tdi). It failed mot last week, non of the things seems to be 'major' but I have lost a bit of enthusiasm for it plus the plan was to sell late April time, so not sure if to spend more £ and time on it for mot, or try and sell 'as is'.
I'll start with the bad;
Failed on;
-rear number plate bulb (!)
- front wheel bearings
- front brake imbalance (both sides)
- both headlights have condensation in
- front outer track rod end ball joint
- steering box drop arm ball joint
- passenger rear chassis leg has 3 small holes (5-10p size, pics below)
Goods points/spec;
- 208k and had partial re-build around 100k which included; new cylinder head, gasket, thermostat, piston rings, big end bearings, refaced valves
- apart from those 3 little holes the chassis is solid - boot floor, inner front wings and sills all been done (sills replaced with box section)
- hd clutch and hd clutch fork fitted this month
- oil/fuel & air filters and oil changed this month
- a frame ball joint fitted this month
- rear cranked trailing arms with new bushes
- allisport intercooler and piping
- 2" suspension lift and 2" body lift
- roof rack
- light bar
- powerflow side exit exhaust
- chequer plated on various panels
- front and rear diff guards
- steering guard
- wind deflectors
- aftermarket (i think?) metal bumpers
- safari snorkel
- modular wheels (15x10) with 33x12.5 gt radial adventuro m/t's
- flexi arches
- towbar
- impreza sti front seats
Good condition exterior, usual scratches from laning but no dents.
hole 1
hole 2&3
Thanks in advance for any help.
Nick.
Just after a bit of advice and what people think my disco is worth (1994 300 tdi). It failed mot last week, non of the things seems to be 'major' but I have lost a bit of enthusiasm for it plus the plan was to sell late April time, so not sure if to spend more £ and time on it for mot, or try and sell 'as is'.
I'll start with the bad;
Failed on;
-rear number plate bulb (!)
- front wheel bearings
- front brake imbalance (both sides)
- both headlights have condensation in
- front outer track rod end ball joint
- steering box drop arm ball joint
- passenger rear chassis leg has 3 small holes (5-10p size, pics below)
Goods points/spec;
- 208k and had partial re-build around 100k which included; new cylinder head, gasket, thermostat, piston rings, big end bearings, refaced valves
- apart from those 3 little holes the chassis is solid - boot floor, inner front wings and sills all been done (sills replaced with box section)
- hd clutch and hd clutch fork fitted this month
- oil/fuel & air filters and oil changed this month
- a frame ball joint fitted this month
- rear cranked trailing arms with new bushes
- allisport intercooler and piping
- 2" suspension lift and 2" body lift
- roof rack
- light bar
- powerflow side exit exhaust
- chequer plated on various panels
- front and rear diff guards
- steering guard
- wind deflectors
- aftermarket (i think?) metal bumpers
- safari snorkel
- modular wheels (15x10) with 33x12.5 gt radial adventuro m/t's
- flexi arches
- towbar
- impreza sti front seats
Good condition exterior, usual scratches from laning but no dents.
hole 1
hole 2&3
Thanks in advance for any help.
Nick.
Last edited: