So I’ve been replacing all my hoses for braided line and both rear main lines as one burst and the other was on it’s way out. All the nuts were absolutely screwed/ welded together by rust. All but one came undone eventually and I had to resort to mole grips as I rounded the front Passenger one off. Only issue is it’s one of the ones that goes straight to the abs module so unable to cut it down and re flare it.
Are there any implications of undoing it from the module using it as a template and re piping using the same copper nickel pipe I have used for the rest. As in, is the end in the module Just a standard flare or is it a part you have to order Pre made.

Thanks in advance

It is like this

3/16" brake pipe with a DIN convex single flare would work. Just use the same male connector as the ones on the ABS mod have a longer shank.

sierrafery said:

It is like this

Click to expand...

Thanks for that, I assume you mean both ends including the one that goes into the abs module itself as well. I will replace the whole pipe with new if that’s the case.

NPG said:

3/16" brake pipe with a DIN convex single flare would work. Just use the same male connector as the ones on the ABS mod have a longer shank.

Click to expand...

Thanks for that! I will cut the pipe and remove the connector in that case.