S

ShaunPDisco

Active Member

• Mar 11, 2015

• #1

Well finally trying to sort out my previous mishap of clamping the wire in the manifold.

Problem is both wires seem to be the same and dont know which way to connect. My guess is, as they are not differet it doesnt matter. Any comments??

 

wammers

No longer with us, RIP

Donater

• Mar 11, 2015

• #2

ShaunPDisco said:

Well finally trying to sort out my previous mishap of clamping the wire in the manifold.

Problem is both wires seem to be the same and dont know which way to connect. My guess is, as they are not differet it doesnt matter. Any comments??

Click to expand...

You will have to suck it and see. Question would be why you cut both wires at same time, unless trapping them severed them both of course. They power a coil when needle lifts it changes the magnetic state creating a pulse. Whether opposite current flow through the coil would have any effect i don't know. One for the electronics lads.

 

S

ShaunPDisco

Active Member

• Mar 11, 2015

• #3

Stupid as I can be......I didnt cut the wires!!!!!

 

wammers

No longer with us, RIP

Donater

• Mar 11, 2015

• #4

ShaunPDisco said:

Stupid as I can be......I didnt cut the wires!!!!!

Click to expand...

Have the wires sheared?

 

S

ShaunPDisco

Active Member

• Mar 11, 2015

• #5

They had seperated afterbeinng clampled and running the engine. Got enough to put them back together but just dont know which was to which!!

 

wammers

No longer with us, RIP

Donater

• Mar 11, 2015

• #6

ShaunPDisco said:

They had seperated afterbeinng clampled and running the engine. Got enough to put them back together but just dont know which was to which!!

Click to expand...

There must be some witness marks where the outer was flattened or a slightly angled cut surely. Otherwise it's 50/50 chance of being correct. Don't think it will make any difference anyway.