William Marshall
Member
Ha ha up here in scotland 80s is a bit futuristicJust wait for an 80's night at your local discotheque
William Marshall
Member
I do have some but I was told this gunges up the system but I don’t know it might be fine?
flat
Well-Known Member
Magicgrotto
Well-Known Member
K seal dunt bung the system up it seals the leak !
William Marshall
Member
Ok so put in the uv stain this morning then unfortunately I had to go fishing to heat the motor up properly haha. Anyway it’s dark now so I had a look with the provided UV torch and to be honest it’s not very clear? There is a tiny bit of leaking at the p gasket so I’ll do that when I get a min. But most of the stain is on the other side some on the engine mounts some on the side of the sump a bit on the bottom of the vacuum pump. I really can’t see where it’s comming from... I’m now thinking it might be from the pressure cap (although that’s new) and spraying water about? I think I’ll power wash the engine bay and have another look in a day or so. It’s so frustrating grrr ducking landrovers
William Marshall
Member
William Marshall
Member
William Marshall
Member
P gasket hmmmmm bit leaky see green
William Marshall
Member
Replaced p gasket still a slow leak grr any ideas I’m at a loss??
Marmaduke
Well-Known Member
Did you use any type of sealant on the p gasket? Was it a genuine one or a blue bag one? Metal or not?
William Marshall
Member
Metal p gasket small amount of sealant part came in clear bag. There is no sign of the gasket leaking
Marmaduke
Well-Known Member
Does your UV light show anything?
William Marshall
Member
It picked up a leak on a heater hose and a small p gasket leak. There is some dampness down the driver side of engine.. engine mount and side of sump but that could be oil difficult to tell. It doesn’t show up very green but a bit mabe
William Marshall
Member
ok I had another look with the UV torch and there may be a wee leak in the bottom hose? Its one of those multi piece ones and there is coolant on the power steering hoses below the three way joint on the top of the bottom hose... but none on the hose? I have a spare in the garage somewhere so thats the next job......
Marmaduke
Well-Known Member
What's a multi piece one?
William Marshall
Member
well the bottom coolant hose I have just found in the garage is a kind of spider think all sealed and the one in the defender at the moment has connections and clips
... ie one pipe to the heater matrix one to the water pump and so on like this https://www.turnerengineering.co.uk...MIxpGwh_zu2gIVz7vtCh0W_g1lEAQYAiABEgJeG_D_BwE
William Marshall
Member
perhaps some of the joins are leaking?? its pretty coroded so I can't tighten up the clips grr the one I am fitting is like this http://www.paddockspares.com/esr329...MIxpGwh_zu2gIVz7vtCh0W_g1lEAQYASABEgLbe_D_BwE
BTW can I reuse the coolant ? its getting crazy draining down and refilling all the time!
BTW can I reuse the coolant ? its getting crazy draining down and refilling all the time!
