M

Mark Wilkins

Member

• Sep 20, 2018

• #1

may seem like a silly question but when fitting a new cat back exhaust how do i fit the the back box section? ive got the centre section fitted but the back box section is proving a pain to slide i’ve the rear axel.

do you have to drop the rear anti roll bar? or is there a trick? thanks

 

Paul D

Old, nackered 'n broke, but the Landy is fine . :)

Events Planner

• Sep 20, 2018

• #2

It doesn't fit straight in, you have to lay it over, push it in and rotate it as the large bend goes over the axle. It might be worth jacking the nearside body/chassis up, so the axle droops if it's particularly tight ...

 

M

Mark Wilkins

Member

• Sep 20, 2018

• #3

yeah the trying to get over the axel is where i’m getting stuck, i was out there for ages trying to work it out lol i jacked up the whole rear end from the tow bar but jacking the near side might work. i seemed to keep hitting to rear anti roll bar at which ever angle i tried to go in on so didn’t know if it needed lowering down?

 

Paul D

Old, nackered 'n broke, but the Landy is fine . :)

Events Planner

• Sep 20, 2018

• #4

Can't recall doing anything when I changed the rear end of my exhaust, certainly didn't need to touch the ARB's. They were removed for green laning, but months after the new exhaust had been fitted.

 

M

Mark Wilkins

Member

• Sep 20, 2018

• #5

maybe some more effort should be put in then when it’s not dark and i’m not tired lol

i will have another go tomorrow

 

J

julesdingle

New Member

• Sep 20, 2018

• #6

Mark Wilkins said:

maybe some more effort should be put in then when it’s not dark and i’m not tired lol

i will have another go tomorrow

Click to expand...

I replaced mine not so long ago- and the back box and bend going over the back axle is not straight forward- literally, it is curve the bend around the suspension at 90 degrees- then rotate back- jiggle and then connect. I had the whole body off so it was easier - but jack the rear up, and remove the rear n/s wheel just to get a better look [and the extra space may help].

 

M

Mark Wilkins

Member

• Sep 20, 2018

• #7

yeah i think having the rear wheel off may help some as that did seem to halt one of the ways i thought may work.

appreciate all the advice

 

discool

Well-Known Member

• Sep 21, 2018

• #8

Yes just remove the rear near side wheel, and approach the axel with backbox pipe upside down ie. opersite to it’s fitted position and twist over the axel. Simple really, I fitted my Janspeed within a half hour 10 years ago ( the original lasted 11years) so won’t be doin that job ever again.

I found it easier to unbolt the exhaust hangers from the chassis and fit he rubbers to the pipe so fitting the exhaust with the hangers attached, hold the exhaust and bolt the hangback on, saving the hassle trying to fit them on the hanger under the vehicle.