jamesmartin
Well-Known Member
not unlike you and bob earlier
Bob is just like a play thing
he tries to wind up and then runs and hides.He's a tosser,but he does have some amusing moments occasionally
jamesmartin
Well-Known Member
it annoys you though ,it would anyone
Actually I don't find him annoying, predictable and repetitive troll bob is.
But it's like a mentally disabled relative that you take pity on
as it appears accy and Roy have.
200tdi ayre
Well-Known Member
jamesmartin
Well-Known Member
tdis are a very buildable engine ,rebore + pistons etc i allways find them a pleasure to do
Langers
Well-Known Member
Hi all -- back again!
Just got round to fitting the new stop solenoid today, expecting it would sort the non starting issue.
And surprise surprise, having the same issues!
It will start and run perfectly with the plunger removed from the stop solenoid. However with the solenoid and spring in place, it won't even cough!
There is a healthy 12v at the stop solenoid wire, and the solenoid can be heard loudly clicking when the ignition is turned on and off. The connection is good and clean.
I've peered down the hole where the solenoid screws into and it looks clean, nothing I can see that would obstruct fuel flow.
This is doing my nut in, what can it possibly be???
Just got round to fitting the new stop solenoid today, expecting it would sort the non starting issue.
And surprise surprise, having the same issues!
It will start and run perfectly with the plunger removed from the stop solenoid. However with the solenoid and spring in place, it won't even cough!
There is a healthy 12v at the stop solenoid wire, and the solenoid can be heard loudly clicking when the ignition is turned on and off. The connection is good and clean.
I've peered down the hole where the solenoid screws into and it looks clean, nothing I can see that would obstruct fuel flow.
This is doing my nut in, what can it possibly be???
timtheenchanteruk
Well-Known Member
oops, wrong cable somewhere then!!
did the same meself of a ZX moons ago, no power to the coil when turning over, but was when running/ ign1
did the same meself of a ZX moons ago, no power to the coil when turning over, but was when running/ ign1
Freediscoranger
Active Member
Agreed, I did the same on the disco when wiring a new wire for the stop solenoid. There's a feed from the ignition barrel for stage 1-2-3 and a 2/3 you need that last one, if you get a multimeter on it and test for voltage on each stage you'll find what each one is. Or clever people might find a wiring diagram somewhere....
Langers
Well-Known Member
All the wiring diagrams I've found have been total bollix... wires are either different colours or missing entirely. Can tell the f**king thing was built by Brummies.
Multimeter will be coming back out again tomorrow... for more than one job... /sigh
