200tdi ayre
Well-Known Member
Im thinking arm pushed through but might as well do lot while in there
If the arm pushed through I doubt there would be much pressure
Im thinking arm pushed through but might as well do lot while in there
takesme about 6 but I aint as young as somederbyshire
2 hours!
thered be lots of pressure.If the arm pushed through I doubt there would be much pressure
thered be lots of pressure.
enough not to press the peddle. the push rod hits the back of bell housing, and if you push the clutch hard enough, it pushes the rod thru the ally housing!
my guess would be the release bearing's collapsed, and slid inside the fork.
be a matter of time before it slides far enough for the push rod to bottom out.
disco 300. theres all the damn rivits to drill out.
was just thinking that, its the worst part of the job. ive started putting screws in with spire clips. much better for next time
disco 300. theres all the damn rivits to drill out.
was just thinking that, its the worst part of the job. ive started putting screws in with spire clips. much better for next time
Not too bad if you've got a little drill and air riveter