R

richiepearce

New Member

• Jan 27, 2010

• #1

the head gasket failed on this so i pulled the head off bought head set and bolts, whilst cleaning the block i found that the liners had sunk.
i have replaced the engine with a running second hand one also distributor type.
The problem i have is no spark at the plugs, i have rechecked all the connections on the loom and all are ok any ideas?

 

jonaf

Active Member

• Jan 27, 2010

• #2

richiepearce said:

the head gasket failed on this so i pulled the head off bought head set and bolts, whilst cleaning the block i found that the liners had sunk.
i have replaced the engine with a running second hand one also distributor type.
The problem i have is no spark at the plugs, i have rechecked all the connections on the loom and all are ok any ideas?

Click to expand...

Did you check the crank sensor? Distributor rotor? Earthing points?

 

R

richiepearce

New Member

• Jan 27, 2010

• #3

will try the other crank sensor in the morning rotor arm and cap look ok i figure that the earth is on as the starter motor runs ok i only disconected the earth lead from gearbox and then reconected after install. I have had someone say that the flywheel might not be compatable but i thought all distributor flywheels were the same?

 

R

richiepearce

New Member

• Jan 28, 2010

• #4

Sorted now broken Lt (coil feed) wire in loom remade now all is well.