woo0003's latest activity

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
  • W
    woo0003 replied to the thread series 3 injectors.
    what would poor pressure do too the injectors? 3 of them were spraying in a split pattern so I have put that down to crap in the nozzles. I have given them all new nozzles. would poor pop pressure cause a split spray pattern? I am not that keen...
  • W
    woo0003 replied to the thread series 3 injectors.
    thanks, I have taken out the injectors, however they only seem to have a steel washer in them. diagrams show a steel washer against the head followed by a copper washer against the injector. is this right? If there are supposed to be copper...
  • W
    woo0003 replied to the thread series 3 injectors.
    do the crush washers have to be replaced every time. or can you put it back together and run it until new ones arrive? thanks
  • W
    hi, what is the process for taking out the injectors in a series 3 2.25 diesel. I have taken out similar cav injectors in a tractor before, but they had the nozzle on the end of the injector. and I think i'm right I saying that the Land Rover...
  • W
    woo0003 replied to the thread Series 3 diesel knock.
    I will get a video from inside the bonnet later. when I slackened off the injectors it wouldn't stay running, and would stall.
  • W
    woo0003 replied to the thread Series 3 diesel knock.
    yes, all working fine. does it sound like diesel knock to you?
  • W
    woo0003 replied to the thread Series 3 diesel knock.
    the link is on the work video, underlined in green. there should be a video attached
  • W
    hi, this video shows the knocking sound that my Land Rover 2.25 diesel has. I am pretty sure its a diesel knock from an injector, however I don't know wether it could be bottom end? or even a hot spot? anyone know what this is? I am leaning...
  • W
    woo0003 replied to the thread series 1 mud flaps on series 3.
    they are rears. I just wanted to know wether the rear crossmemeber angle is the same on the series 1 vs series 3
  • W
    woo0003 replied to the thread series 1 mud flaps on series 3.
    will they fit though?
  • W
    hi, does anyone know weather series 1 mud flaps will fit on a series 3 Land Rover? thanks
  • W
    hi, I have a 1977 Land Rover series 3 2.25 diesel. the cold start light doesn't seem to ever come on. I am wondering under what conditions should the light be on. when the glow plugs are on? it could be that the bulb is blown? thanks.
  • W
    woo0003 replied to the thread 2.25 diesel performance.
    ok, that reassures me, it pulls well up to 3rd its just the large jump from 3-4. from the good starting and good sound im going to assume that the engine is at least good for a few more years/thousand miles
  • W
    hi, I'm looking for some advice on the performance of my 2.25 diesel (3 bearing). I know they don't have the best reputation for power and I haven't driven any other series Land Rovers with the same diesel. it starts and runs ok without too much...
  • W
    hi, I have a series 3 2.25 diesel that has a slight miss when cold and a constant knocking sound. when started cold, the engine seems to be missing or poorly firing on one cylinder. it sends a shake through the cabin and a puff of smoke from the...
Back
Top