Hi Masumbulla
Apologies for not replying to your post sooner I have only just picked it up.
He has always been very helpful to me and his rates are very.
Mention Mike from Swavesey
Let me know how you get on.
Simon Henderson
S.Henderson - Mechanical Engineers
Unit 4
Mereside Farm...
Hi Leedoherty
I always use a guy based in Ramsey for any work I require he has Autologic Diagnostics and he Knows his Land Rovers and his rates are reasonable. Send me a PM if you are interested and I,ll let you have his details.
Safeman
I have now checked the pipes at the compressor one is freezing the other is only warm not too hot to touch as suggested. Does this indicate its low on gas?
Hi All
I have tried all the settings suggested and the distribution appears OK for all positions as do the temerature settings variation from lo to hi. Can you please advise where the heater core temperature sensor is situated and is the replacement a DIY job.
Regards
Safeman
Hi All
The above symbol has started to appear on when the engine reaches operating temperature. The air compressor clutch is functioning correctly and the flow and return pipes appear Ok (one warm the other cold). The temperature at the outlets in the car appears to be OK.
Any suggestions...
Many thanks landy10 for your quick reply to my post. All hubs were cleaned and seated properly. The discs are Rossini grooved and ventilated which are a very good quality. The wheel bearings were not checked at the time but the car passed it's MOT 2 days ago which I would have thought would have...
Hi All
I'm experiencing fairly violent judder through the steering column when under braking. A few months ago all discs were replaced with vented one together with green hard pads. Everthing has been OK until recently when the juddering suddenly started. Any help and suggestions would be most...
I believe the auto dimming mirrors were only fitted to P38 4.6 Vogue models other models dont have the two extra power wires in the wiring loom to accomodate this function. These were also colour co-ordinated the same colour as the rest of the car.
Regards
Safeman
I removed the stalk and found that one of the cams which cancel the direction against a pin on the steering column had over shot the return spring. I pushed the cam back into position where it should have been and bingo everything works as it should do. One multi plug connects all the wiring...
Hi Sirus
Thanks for the suggestion.
I have tried holding the stalk whilst making the turn and then letting go which did appeared to work but now I am unable to indicate a right turn unless I force the stalk in that direction and forceably hold it in position. I guess I need to remove the...
Hi Everyone
The direction indicators on my 1998 P38 4.6 HSE cancel before the turn is completed. Anyone any ideas how to rectify this annoying problem. Any help would be most appreciated
For reference the new alternator is a Denso 120amp/hr and the new battery is an Exide 75 amp/hr . Both these were changed due to the vehicle failing to start if not used for 2/3days. I would also add that the Rf Receiver was changed to YWY500170 after reading various posts on this forum about...
Hi Everyone, Having recently fitted a new alternator to my P38 4.6HSE I was wondering what the voltage should be if checked across the battery terminals with a volt meter and with the engine running. Anyone Know? This is my first post on this site.