I managed to find the photos elsewhere. Make what you can of them, I didnt take them to document too much of the job, so they arent great to show what I needed to do. You can see on some of them though the lip that runs round the bottom of the wheel tub, the wing floor sections kind of sit...

Not six, but four, its an unloved D1, so more rust than steel. SteveB, I think I took a few, cant promise too much though, I will have a look when I get on photobucket tonight.

Ive just had the interior out of my 94 300Tdi, this was what I had to do. For bolting the seat base to the floor, there are two bolts that thread into captive nuts, they are the two in the middle of the car, the two on the outside next to the sill, they are 10mm headed bolts with a 13mm nut...

Just to update this as when you search 'discovery rear inner wing floor' on google this is the second link. The floor sections were spot welded on and then covered in seam sealer. I found the bedt way to remove the floor sections from around the wheel tub was to simply cut it, just a bit...

Morning all, I have a couple of small issues that I need to sort out before I send my D1 off for its MOT. First, I have a bit of an issue with the indicators. Its an odd one. All of the indicators flash as as though there is a bulb out (really quick), but there isn't. When you flick the...

Ive looked at YRM, their outer sills dont look particularly easy to fit, unless someone can tell me otherwise.

I need to get new inner & outer sill for both sides of my Disco but could do with a bit of a steer on where to get them from. I want to replace them fully because they have rotted through on the area's that make up the floor too, and the seatbelt mount has rotted off the driver side, so I want...

I dont need new, just a pair that dont have half a seized bolt in the top (the bolt holding the seatbelt down was seized and the head had to be ground off)

Can anyone point me in the direction of where to find a pair if rear seatbelt mounts for a Disco 1. Mine are pretty goosed so I do need to replace them, I found this image on here from someone else needing them in the past...

The problem with trying to patch them is that there probably isn't much/any foot metal on the old sections to weld to

Landy noob in need of a bit of help please. Ive been looking to get the rear floor repair kit from MPS (floor, supports and inner rear wings) to sort out the slight corrosion problem that these Disco's tend to have. Ive already taken the boot floor out of mine and seen what I need to do with...

Do you have to make any changes to make use of veg oil?

Hello everyone. Im Trig. Ive just got my mitts on a Discovery 300TDi in need of some TLC and a fair chunk of welding. Ive never played with anything from the Land Rover stable before so the collective experience of the forum will no doubt prove to be indispensable.