I also fitted a k+n type air filter, the pipe from the air filter to carb was rotting and allow debris to get into the carb.

I have a 110 2.5 petrol. I had all the same problems as you, it took me ages to figure it out. In the end it was crap in the carb, I sent it off for a refurb and its been fine ever since. Also, make sure the 2 solinoids that go into the carb are working, iirc, 1 is idle control, the other is...

When I saw the cost of a genuine seal, I made my own with a camping/roll mat.

Yep, came from inside the engine, attached to the magnetic sump plug along with the usual swarft.

Doing an oil change on my landy. 2.5 petrol, and this was attached to the sump plug, any ideas? Lighter for scale.

Great video, and a great channel;

.

Wrong thread

Does it run ok with that carb on it?

I used tiger seal, can be removed with a hot air gun if needed.

Gearbox was working fine and still is. Can I check the to see where the pin is missing without taking out gearbox?

Cheers james. Is it fatal?

Drained the oil out of my mates 110-lt77. And this was on the drainplug- any idea what it is?

Update. It was a tooth out, took bloody ages to get it right, had it set up perfect, wound it over a few times-tooth out! Anyway, got it right in the end, and started 1st time! cheers guys.

Is there any reason that I cannot start it briefly once the belt is on, before I fit the timing cover/waterpump/rad?

After watching that video, I reckon i'm a tooth out. Had a read on the net, and it seems that being 1 tooth out can make all the difference. Will strip it down tommorow and have a look.

Hi chaps, need some help please. 2.5 n/a 110. Changed the timing belt and tensioner on my mates 110 for him, I used this guide;https://forums.lr4x4.com/topic/7880-25-na-timing-belt-replacement/ I lined the timing marks up and after I fitted the belt wound the engine over on the crank with a...

Yep, clean the earths.

Now i'm sure some of you old farts(like me) can remember when water pumps had grease nipples on them. Ive just bought a new water pump for my mates 2.5 na and the water pump has a hole where I assume the grease nipple used to go. Is there ant reason I could not tap a thread into the hole and...

The CELLULOSE could be causing the problem.