1. R

    P38 Aircon/blower problem - help!

    Hi there I would guess that your blower regulators have gone. Two new blowers I would hazard.
  2. R

    Been A while!

    Hello all Been a while since I was on here. I thought I would update you with my P38's progress. It started smoking really badly on start up and pulling away so I took a punt on a 2nd hand 4.6 engine with 72K on the clock. It has gone in and seems to be working very nicely so far...
  3. R

    P38 4.6 Smokey at start up

    Ok Thanks
  4. R

    P38 4.6 Smokey at start up

    Hi All My 99 4.6 145k miles has started smoking at start up. Its not loosing any coolant so its not water looks a bit bluey and is using alot of oil. Any ideas? I'm guessing its rings? it only happens while the engine is cold and in the first couple of hundred yards of driving. As soon as...
  5. R

    P38 ECU problems?

    Hi get it into a good specialist
  6. R

    Engine issue and a big issue at that.....

    Hi mate When I got my p38 it was overheating and loosing coolant. It turned out to be the block so I used some ceramic fluid stuff that gose in the coolant and hey presto it works just fine! Try that first before spending loads of cash!
  7. R

    Where can I buy a front proprshaft

    Hi there The UJ is knackered lots of play (just had my radius arm bushes replaced) and sounds like I have a small animal stuck to it knocking on the bottom of the car as it goes round. I wanted to get a whole balanced prop shaft rather than replace the UJ and get it re-balanced etc. It will...
  8. R

    Where can I buy a front proprshaft

    They only have a 3.9 listed. I'll email them but is there anywhere else?
  9. R

    Where can I buy a front proprshaft

    Hey all Can anyone reccomend somewhere to buy a new front propshaft for my P38 Auto 4.6 please. Other than LR. Many Thanks
  10. R

    p38 Radio LCD

    Hi I sent mine off to Clarion repair on Ebay they refurbished it and added an ipod cable for less than 100 pounds inc postage
  11. R

    K&N Cone Filter will not fit 4.6 2001?

    Hi there I removed a cone filter from my car when I purchased it and replaced it with the standard airbox. You are welcome to it if you want.
  12. R

    Heater Blowers Not Working

    Hi Simon My drivers side blower had a burn't out terminal once repaired its working fine. Ive been told the blower circuts can be problematic and often its the electrics rather than the blower itself. I would run it into a good landy mechanic to have a look.
  13. R

    Ceramic Liquid lining any good?

    Hi guys The liquid sealant has done the trick and its working really well. Cheers Ron
  14. R

    Ceramic Liquid lining any good?

    Thanks for the replies chaps. I'll post up how I get on. Cheers Ron
  15. R

    Ceramic Liquid lining any good?

    Hi all my 4.6 has been diagnosed with porous block and there appears to be a crack that opens when under load. I'm going to try some liquid ceramic liner as an interim and probably take the middle out of my thermostat to keep the temp down so the crack does not open up. Does anyone else...
  16. R

    Ipod/Harmon Kardon

    Hi I have the clarion unit and te clarion service centre will add an aux cable for 19.99 I have this and it works just fine
  17. R

    tailgate lock

    Have you tried replacing the tailgate lock button itself I did this and it works first time every time now was very cheap to purchase from fleabay
  18. R

    HELP!! overheating problems

    Hi take the cap off the water reservior and let the car run it should let the air bleed out. Let it settle over night and top up in the morning. It might be worth flushing the system out with a hose.
  19. R

    AC Fan Relays Hot?

    Hi all Whilst trying to understand why a previous owner had done some extremely creative wiring under the bonnet to the aux fans I discovered that my Aux fan relay (the last one of the two) was brown on one side where it looked like it was burnt. Both of them seem to run very hot and the wires...
  20. R

    AC fixed ut ook still comes on??

    Hi all Have replaced my heater vent and blender motors as they were not working. Had a leaking AC valve so that was replaced, the expansion valve was not working and the pressure switch. All replaced now with new gas but I still have the little book come on?? Any other ideas?