pwood999 - thank you very much! That worked out great - the windows are closed and I now have peace of mind and can prepare everything else in peace. This was my setup: I quickly built 2 plugs

thanks! but how should i proceed? plus on the 1 and minus on the 2? then plus on the 1 and minus on the 3? .... i have now checked all the PDFs but nothing says how to trigger it. I phoned my LandRover dealer today - the next available appointment is in 8 weeks! Everything I do - is at my own risk!

Thank you. The question is, how can I switch off the window regulator? I would like to disconnect the car battery and trigger the whole manual with a wire. In other words, energise the motor of the window regulator.

I have another question. For a long time I have had the problem that when I open the car on the remote control - all the pins go up - only the one on the driver's side stays down - but you can clearly hear the motor running. As I took the panelling off for the first time today - I could...

Thank you, I have read the Electrical Troubleshooting manual pdf. But it doesn't show the plug from the motor - but the individual plugs - I don't understand anything about that. Here page 249 - I think...

I can try it out - is it always plus cable at the top and then minus at the bottom?

I have found the Electrical Troubleshooting manual pdf - but I don't understand it...

my PDF only has 1360 pages?

I have the PDF file with the 1300 pages - but nothing is stored there under Service repair no - 86.25.04?

1) Do the mirrors move correctly or are they also not working ? if I engage the reverse gear, then yes - otherwise they don't work (in neutral) 2) Does the car lock & unlock normally ? yes I have removed the panel. I have also found the window motor. The plug has 6 pins - can someone please...

I have tried it - unfortunately nothing happens. I will now remove the door panelling - then remove the battery and connect it to the motor via a cable. A lot of effort....

Thank you. I was driving my car as normal and the two front windows were down. I parked the car. After 1 hour I drove on but the windows could no longer be closed. Currently both front windows are down.

the box can be pulled out to the front. but in my case there is only a gap - then it gets stuck on the cables. at the back all the cables look good. I cleaned it and reassembled it - unfortunately without success. If I remove the door panel - can the motor of the window regulator be...

Do I have to remove the seat to do this?

What irritates me is the following: I get into the car and realise that the console is not working. I get out of the car, grind the fuse a little, put it back in and it works. 1 hour later the console fails again...what could it be? that's frustrating...

hmmm, none of this works. I'm now covering the windows with film. How can I access the connection from behind?

I have already tried this but it does not work.... There must be a loose contact at this connection - I have no other explanation. Is it complicated to remove the whole thing? Can I bridge the fuse with a wire?

Good evening everyone, Unfortunately I have a big problem. I've already found out that the first fuse is responsible for the console. Until yesterday, everything worked perfectly. Today the failure again. I took the fuse out again, ‘ground’ it a little and put it back in - it works again. Now...

ok, the problem is solved for the time being. unfortunately I didn't proceed systematically. what I did: - pulled out all fuses (including those in the engine compartment) - checked - all fuses were good - treated with contact spray - Checked the cables under the passenger seat and the plugs...

Good morning everyone, I checked - the plug is tight. I pulled it off and treated it with contact spray - no improvement. The fuse box under the hood looks good. Checked all the fuses - each has 12.15 v. Nothing smells burnt. Everything on the car works - except the panel. ...will first...