Oh don't get me wrong I absolutely love the car but I've only done a few hundr d miles since I bought it and I've had to rebuild the gearbox, my front left suspension airbag now has a hole in it, the CD player has packed up and it needs four bushes underneath.... I would have expected a few...

Did anyone find a solution to the artificially intelligent steering column moving down on its own? I have the same issue :/

Hi, I have a 56 plate 3L Diesel Vogue SE with a steering wheel fault, when i key off the rake motor runs on for a while after and when I insert the key and switch on the ignition, rather than adjusting to the pre-set position, the steering column drops to the lowest setting and has to be set...

So I have had my box rebuilt, standard torque converter failure, clutch plates burnt out, new complete seal kit, filter and pump parts replaced.... the whole box has been checked out by a specialist and anything on its way out or not perfect replaced. Spent my evening putting it back in and...

Ooohhhh bugger Thanks Saint.V8 you have eased my mind a little as I was thinking someone had over filled it to hide problems. Cheers! I am releaved but I'm still stuck with the other fault that's happened twice where it revved and didn't move, that and the fault code gearbox monitor 3 - 35...

Ohhh.... so this is normal if the engine isn't running? I selected all drive, neutral, reverse and then back to neutral but didn't have the engine running when I actually took out the filler plug? I was told to expect a trickle or none of it was low but about a litre flew out.... hence why I...

P1884 (35) * CAN message: Engine speed invalid Maintains current gear in low range, limp home mode in high range. Shift pressure to maximum, harsh gearshifts/engagement. On On This code again

Yes it's my brothers garage they fix anything that has an engine, it was my dads garage for 37 years before him and my brother has the same car just 2 years older although he doesn't rebuild gearboxs really as it's more specialist. He's going to call his gearbox guy in the morning for me...

Well that was an experience Had it up on the ramp, warm but not hot and took out the oil filler plug on the top left side and litres of oil came out I was expecting none or a dribble not tons...... Now I'm worried ☹️

Ok I won't drive it except to the garage to get it looked at. Apart from oil level/condition what other checks should I be looking at doing?? No codes this time, the only other this is it feels like there's a little kick when you go into drive like you feel it engaging or not engaging...

Hi, yes :) it does this fine sometimes but other times the motor runs continuously until I press the lever and then it doesn't go up or down only in and out. Then some other times when I put the key in it goes all the way down and squashes my legs unless I stop it first? Or up to the top of its...

First one for a very long time. Seems I must have had my right foot on the accelerator as I put it in drive maybe. Cleared the code and one other for steering wheel position but apart from that totally clear and all good. Hopefully I didn't damage anything but I'm very relieved it appears to be...

P1884 (35) * CAN message: Engine speed invalid Maintains current gear in low range, limp home mode in high range. Shift pressure to maximum, harsh gear shifts/engagement. On On Sooo was that me trying to get into drive and take my foot off the brake to move too quickly?

Ok so I just got in and drove 40 miles, no code warning on start up or the whole way to the garage. I hope it's still stored it? Very odd

I have a feeling the previous owner did this as the clocks went set which did make me wonder why, thanks I will get the code read then give this an go and update.

Thanks guys, I am praying I don't have to replace it as has had a reconditioned one already at 130,000 miles by a 4x4 specialist garage :/ The small jolt is what concerns me, felt like when a manual car pops out of gear?

Hi everyone, I am new to the forum and could really use some advise. I have just purchased a 2006 Vogue SE 3.0TD6 with 150,00 on the clock, 3 days in and after a small jolt putting it into drive at traffic lights the transmission fail safe error code has come up and warns me each time I...