Gap iid is the way to go I have one for my 2008 3.6, it does the lot so its not a waste of money I have reprogrammed the ccf to do away with drive away locking, enabled auto wipers and wipers to intermitent when you stop at lights ect. Not done suspension calibrate it will do it, "Sams motors...

Had the leccy fan go bad on my 2004 it would kind of stutter on start up like it didnt know which way to rotate then stop at which point a/c would cut out, got a second hand one in the end that fixed it. There are electronics in the motor casing as well as the motor and yes they do do the...

I have one, bought for the 2004 td6 I had at the time just to warn you it wont calibrate the EAS even though it says it does it will read and clear faults in it though. It will read and clear faults in a lot of the ecu`s, I know it reads oil temp in the gearbox and faults but what else I...

Might as well give battery reset a go might just do the trick.

Mines a 2008 tdv8 3.6 and as far as I know there is no electric pump for the heater, there is one for the FBH but that only kicks in when engine cold. There is however two valves at back of the engine on the bulkhead that controls heating when engine running.

Plus it could open up a can of worms!

2003 model l322 didn't have reverse camera fitted as standard so it must be after market, there is a way of fitting one if it has the TV unit fitted I did it on my 2004 think we need more info or pictures of camera for clues.

Doesn't yours have the iPod connect thing in centre cubby box ?

Can't help much other than 2007 didn't have led or angel eyes for a start.

Both end caps pull off the same.

Yep, that's the part.

When you get tracking done recalibrate steering angle sensor, if that's out it will kick abs in (been there done that ).

The tdv8 is known to leak from 2 "O" rings at top rear of the V back of the oil filter housing and run down onto bell housing, you need to remove heater plenum housing look down back of engine for a silver pipe, (sorry chaps and chapesses but got to mention that other forum again) have a look on...

On my phone but here goes, from memory there is a plastic bracket that holds the motor in place that breaks hence noise but no movement about £40 or was few years ago.

Anybody good at french then ?

Bit late to answer ( sorry @kermit_rr ) but think it can be done with the Gap iid tool.

Threw some water at mine yesterday to get some dirt off it but after driving through what seemed like a cloud burst this morning returning from shopping I might as well not bothered it`s nearly as bad again !

Friend of mine has one with the 8 speed and unless your right foot is on the floor you will hardly notice the box change.

Just had to go one better did`nt you @kermit_rr with your £141.9 ! not saying I`m jealous like.

Had a ride out to toolstation in Sleaford pick up couple led lights ( lincoln branch had two goes and broke them both times) filled up while there diesel £154.9 a liter against £168.9 in lincoln made it worth while:) only took 78 liters.