Waste of money!

Used paddocks performance silicone ones from paddocks for years, no issues.

Looks quite real but you need to check all the paperwork to be sure. I almost bought one a few years back for 700

Service the injectors

And check the plugs and the coil, king leads can corpse quite quickly up inside the coil.

If you plan going under the motor make the stand highest taller than your girth.

5t trolly jack with a wide wheel bas as possible and some 5t or 10t stands. These things need to be over spec on weight Don't scrimp if it falls over during a lift with no wheel on the damage will cost a lot more than a good jack to repair.

Which type of snow are you looking to drive on?

Rare? Still has air suspension and liners don't go up n down with the pistons

Hydrogen and oxygen in a 2 to 1 mix. It does get cold in England so put some antifreeze in there also match the colour to what is in it. You will find most what you need under the bonnet, if not sure look under the hood?

eBay is your friend, buy a scrapper and rip the bits off.

Misfire? I.e. One plug not sparking. Are you touching a lead to earth with the air cleaner.

Cheap nasty brit part sensors, I was sold one a few years back and got a refund cause I had the same issue as you previous. It's not an easy resolveI ended up with the stilsons on there but you may be able to get a chisel in and knock it round, there ain't a lot of room.

If your doing whole sills use box section, some real good posts on here about it.

When shooting years back in my 11a I used to find having a springer spaniel or 2 sat on your keee helped warm you up on a cold morning. Careful when they are muddy n wet at elevenses though.

If you had to drain the water out I guess oil won't run out so refil with the right stuff. Not a bad job to change if the balls are good.

Run And don't look back unles you can weld and have lots of time

Yrm is your friend, the best panels if you ask me. You can get the front inner valances in sections so either replace the lot or individual sections, personally I would do the lot. Looks to me like it's a seam sealing and where fasteners were just like on a RRC, should get lots of advice from...

Don't look like a real one. I almost got one on the bay of fleas once, had the rear walnut pick Nic trays n everything, this one aint

Thought it was smart phone and Grindr these days