Got bogged down on a green lane and then when I got back on the road had massive steering wheel shake. Checked it out when I got home and found I have required a massive wheel wait

Try it in the discovery part of the forum might get more help there.

I looked at the site discool said and it said the part number is amr4948 I found this but no pic http://www.johncraddockltd.co.uk/superseded/amr4948-use-8510043.html

It looks different. Is it for a auto box

Hi I was in the Peak District when my auto gear box temp light came on. I diagnosed it as a faulty sensor as when the box was cold the light was still on and when I disconnect it the light went off. So it looks like I need a new one. Can any one tell me where I can get one please. Thanks

Brakes are sorted now. Adjusted the rod like James said Thanks.

Thanks I will give it a go tomoz and let u no

I've replace my brake servo and master cylinder with a secondhand one after brake fluid was leaking from the master cylinder into the servo now all the brakes are seizing on and the only way to push the piston back is to release pressure by opening the bleed nipple. I'm convinced it's...

Not all today but this week i Replace front prop Replaced brake servo Tie raped cables under dash Welded rear axle trailing bracket Welded rear shock mount Welded rear crossmember Wired low brake pad warning light Not far off ready for the Peak District.

Looks like I've brought s duff one then. Thanks agen James I will get back on eBay

Hi, Just got a used diff off eBay and it has a lot of end float 1.74mm. I checked my old one that I blew up and it hasn't got any end float. The new one is off a td5 and the old one is from a 300 tdi disco so don't know if there a different design and this is normal

Thanks James I will get on eBay.

Thanks James. Is there any diffrance in splin number or ratio. If it's a 3 blot flange can I just swop it with my 4 bolt one

Did a quick search on this but couldn't find anything. Blew up my rear diff today and was thinking if a diff from a newer landy will fit in my 200tdi 1994 disco.

ow its the later std type oil seal

this is the second seal i put in. the first time it was off the car so would of noticed it and the second time i slid it over the shaft which has a shafer on it. will seal number 8 on the drawing hold any of the pressure as they did not come with the kit

sorry for got to resize the pic

hi, i have replaced all the seals on my pas box after it started leaking. it worked fine when i went on a test drive then the next time i used it it started leaking again. i replaced the steering column oil seal and dirt shield but the same thing happened again. i've just taken the box off to...

Yer tried that gratch. Like James said looks like I need a new one. I like driving through deep water. Is there a water proof one I can buy

Tried putting 2 jump leads on the starter with a wire from the solenoid to + and it's the same