I have picked up a 2.25 diesel engine, engine number 36103158a 188ueg Erc4940 Cylinder head 25l3 Hrc1353 From what I understand the block is a petrol block, can anyone tell me if the block, camshaft and the rest is identical to the diesel

I have a 1959 series 2, the engine in it is a 2.25 diesel, I'm trying to find out if this is the original engine as im not sure if they put that engine in for that year, can anyone shed any light on this?

Where's the cheapest place to buy a new 2a chassis these days? Do they only do galvanised ones now?

Series 2a bulhead repairing The bulkhead has been shotblasted but there is holes where the handrails and the clocks sit in. How do you remove the handrail as it is spot welded and i cant get the drill in to remove them.

Gonna remove the box next week, How hard is it normally to get out?

hi james what do the 1st 2 clutchs control in the gearbox?

I believe the previous owner had the fault code read and he said something about the gearbox speed sensor been faulty. As far as i can remember reverse was okay. From what i understand if the gearbox input sensor is reading alot different from the gearbox output sensor it sensors clutch...

I have a discovery2 which when setting off in D the car would drive and rev to 3000rpm then go into limp home mode. I have drained some oil and compared it to ATF dextron2 and it looks dark. Do you think its the clutch and which one?

Does anyone have a discovery2 xyz switch cheap ? I need one for test purposes so i can check the gearbox with it, Then if its not that i am going to pull the gearbox out. So if anyone also has a good working gearbox forsale can you let me know?

I have private msg'd u.

If you have a working one would you sell it to me?

The garage didnt give me the codes but the have said on the reciept fault traced to xy switch, I can get D and P but if i put it in neutral or 123 i cant get the light or display to display the gear, should i be able to get neutral by turning the switch?????? I have also turned it with a screw...

I have a discovery2 TD5, After driving in D a couple of yards the s&m light flashes and goes into limp home mode. I had it diagnosed and they said it was the xyz switch. I have took it off and tried to clean it but when put back on i got my brother to sit in the vehical and i turned the switch...

Does it go in the top of the RAD and out the bottom

Which way does the water circulate on a p38 4.6 v8?

Finally completed the o ring change without cutting the pipe with a bit of a struggle, The only problem i have now is an airlock, i thort all the air was out and drove it up the road and the vaporiser froze,the gauge sat at the normal running temp and never went up, I felt the bottom hose and...

Looks like it has the holes but the pipe aint been cut

Hi just started taking it apart, Looks like its been done before as the hole is already there, How do you get the plastic pipe out as i dont want to cut it?

The heater matrix o ring is leaking, Can i get at it to undo the screw for the pipes if i remove the radio and the hevac panel? I have seen the guide on rangerovers.net and it says u have to break or drill a hole to get at the screw.

Just looking at the p38 gearbox (ZF4HP24) I believe this gearbox was also used in the Jaguar x300 - Would the jag engine be a good replacement for all them dead v8's, Would the engine fit onto the p38 gearbox?