Hi thanks for your response a full rebuild all that you mentioned been done except the injectors not been refurbished thanks much appreciated

Hi just finished rebuild on my 200 tdi engine but still blue smoke when I rev it but not on idle can’t take it for a good run as it’s a rolling chassis any ideas much appreciated thanks

Hi yes a lt77 box and a disco 200tdi engine but the wading plug hole isn’t in line with the flywheel to lock it to set the timing on the pump would it be a different bell housing

Would the arrow on the housing be ok to set the timing on the pump

Flywheel bell housing hole for locking pin not in line with flywheel what next any ideas for locking flywheel at TDC Much appreciated thanks

Flywheel bell housing hole for locking pin not in line with flywheel what next any ideas for locking flywheel at TDC Much appreciated thanks

Which is the best crankshaft rear oil seal to use and is it fitted flush to the front or to the back thanks

Hi any ideas for cleaning debris out of a stripped down engine block

Hi thanks for your response I will have a look tomorrow on the piston walls but on the pistons crowns there’s number Tx err 1387 The crosshatching is still good the pistons ring were free and pretty clear but there were carbon marks on the side’s just around the conrod pins up to the rings not...

Hi just stripped down to the pistons out stage so what should I be looking for on the pistons and rings and how to find what size rings are on as no reference numbers and how far do I continue or I am at the point of no return thanks

Disco 200tdi camshaft Hi thanks for your response tried a bit of heat and plenty of wd40 and clean up the shaft and the laser puller still no joy

Hi yes the cam sprocket first and then crankshaft damper came off ok but it’s the crankshaft sprocket behind the damper which is the problem thanks much appreciated

Hi started stripping down to get to the cam everything was going fine until I got to the crankshaft spocket I used the puller which uses the 3 screw holes on the sprocket 2 hours later still the same any ideas much appreciated thanks

Hi thanks for your response would you mind if I asked you whereabouts you purchased your cam and followers etc it seems to be a good price thanks

Hi thanks for your responses so if I fitted a new cam would I need new cam bearings as well thanks

Hi thanks for your responses so could I use a good second hand or new camshaft thanks

Hi I was thinking of replacing my camshaft which as been scratched with a damaged cam followers roller Would I be able to use a good second hand one or would it have to be a new one thanks

Hi the bad news turbo man was right bad workmenship i took the head off to find two tapper caps one bouncing about with the tappers and half of one down the side of the cam followers and it looks like it’s marked the back last two cam followers rollers and the camshaft just wondering if I could...

Hi thanks for your response much appreciated so where’s the gas /air coming from and what’s the issue thanks again ps I was thinking about purchasing a cylinder leak down tester or am I just wasting my money thanks again

Hi all 4th video is after 20 minutes as you can see the smoke isn’t as bad At the exhaust end doesn’t smell like oil more like diesel Only purchased the engine a couple of months ago not sure of it’s history or it’s mileage and it’s a disco 200tdi. Conversion and any of your thoughts would be...