Wide track 509kgs empty Loaded MAM 1190kgs Narrow track 373kgs empty Loaded 1000Kgs But I’ve seen 1100kgs loaded mentioned too

Because the roof will and has tried to move apart a ratchet strap to get it back to where it should be. Need to cut the old roof gutter to angle the sides to match the angle of the side panels. It may look odd when the front roof panel fits back on with the bottom now wider than before by...

Not a lot has happened on this recently. Managed to panel in the front section, need more steel, and plenty of welding up supports and protective bars/tub supports to be done.

Now it’s the boring bits! Body panels and stuff Booo

Latest idea is (depending on length) slide it down the front. if your savvy you could put twin runners so you could position it up on top either facing rearwards or sideways. Slow progress at the moment waiting on some bits to come. After next pay day i need to put an order for a shed load of...

Latest idea is in channel and slide it forward and down the front. We shall see simple is always best

It’s a cheap roof lodge thinking of maybe turning it sideways and cutting and bracing it. Will be horrible inside but maybe the answer

My 90 is a wreck, I’ve got a half finished 80 series 1 CCV motor which needs attention lol Plenty to be doing but the trailer is taking up the time at the moment. If the weather turns then i’ll be stashed away for a bit. Still need a solution to keeping the tent low. So far thinking of...

Today’s progress

Yea there is plenty of give and adjustment. I’ve just fitted a 109 roof to Bros 109. Took the good and sticks off. Placed the sides on the trailer. Latest idea is to sink the tent into the roof line. Means the tent needs to rotate 90 degrees and go off the side. We shall see. Might be better...

Collected a 109 hard top and sides this evening. I really want to cut the sides to half height to be able to keep the roof line low as possible and keep the roof tent equal to or under the 90’s roof line when being towed. Also allows access to store in an up and over garage type garage should...

Erm, First off. Your vibration could be the pinion bearing in the diff. Check that by seeing if there is any up and down side to side movement. Anything felt is too much. (Pretty much) Diffs, Front to back are the same, Late 24 spline series III shafts have 24 at the drive flange end and...

Bit more work to see if I like the paint

I’m not wholly convinced about the tailgate yet.... I like the look however you cannot really remove it and the front needs some support. I am thinking about a landy radiator panel. Need to Measure. That way a set of LHD lamps could be in the trailer should you need to swap lamps over you have a...

ALRC Nationals 2019 What a blast!!! Roll on next years National in Kent! Hope all you guys and girls are all having a good time! There was talk of a semi reunion at Peterborough LR show Anyone up for it??

A bit more ideas,

Hi fellow LZ people! Long time no see been busy with trying to get landies out either trialling or racing on the odd occasion. I have a new project I’m semi halfway down. It’s a slow project and very much on the cheap. Want: A base to camp when greenlaning, a base to stay when out at...

I’ll try and get some in car footage, can put them against one another and your be at least 60-80 seconds faster per lap

Yea looks cracking!! Part of the moto X track too