300tdi Edc has maf sensor ,4th injector wired,fly by wire throttle not sure it might also have a crank sensor???.belt is good a serviced regularly.

Just as I exited a dual carriageway seem to lose cruise control but then found throttle was unresponsive pulled over in a cloud of thick white smoke idle was lumpy would not rev above 1500 rpm and very lumpy with lots of smoke and engine check light lit up then went out and smoke stopped hmmm...

With it locked and bonnet switch down got 0.02 same as before has been starting fine last couple of days does this now and again but will go bad soon going to clean up earth's, battery cables, starter and alternator connections this weekend.but have noticed headlights are not very bright (Osram...

Got a reading of 0.02

Ok thanks for the help electrics are not my strong point not sure what setting or where the leads are supposed to plug into the meter here's a pic of what I have.

Had trouble starting after standing overnight turns over very slowly but turns over alot quicker and starts straight away after a short journey already put a new battery on made no difference.tonight disconnected the battery at work and left standing for 11 hours reconnect and turned over...

T1 7219 12v miniature bulb 0.06amp 0.72w.around £5 for ten.

All switch's now lit up.bulbs for the heated seats perfect fit but the window switch bulbs are bigger but the same bulb can be used but the green cap (which gives the bulb colour) is a floppy fit had to double it up at the bottom.

Heated seat switch's all done but pulled apart the window switch and yes it's a different sized micro bulb soldered in oh the joy of owning a land rover :).does anyone know what bulb it is?.

Ok thanks everyone going for Armstrong as for gas shocks maybe next time if I can afford them.

After changing the top bush and lower rubbers on the rear n/s shock 3000 miles ago I find that it has trashed everything I have done so new shocks time.changed all four 70,000 miles ago (britpart) so probably long overdue.as with many people on a very tight budget so it's britpart or Armstrong?.

Thanks for the help but definitely not t5/286 think they are known as t1.pack of 10 12v 7219 that's the ones used on the second video.

Anyone know the bulb number or where I can get them as not paying an extortionate price to have it in the holder and will need 6 of them.

I stopped today and recovered the bumper end and found the headlight washer jet bit will be fixing it at the weekend with my land rover repair kit

Sorry yes it's the bumper that's bent caught him on the corner so it's pushed it in not as bad as I thought.claim will probably not go in my favour as in trying to avoid a tee bone I hit the rear corner of the car my experience with insurance company's shows they see black and white and driver...

Just met a nice gentleman who pulled out Infront of me at a roundabout stood no chance of stopping and barely got my foot on the brake the front cross member has been pushed back a good way and both headlights are pointing down a long way you can see how far it's gone back.also is it still...

Head gasket was my first thought and they can go in many ways I would say your compression gases are getting into the cooling system this would not give you oil in water or steam from the exhaust can be confirmed by a sniffer test.had it on a golf heaters stopped working then a hose burst...

I would advise getting the head checked for warpage while it's off or you will be wasting your time and money.as sparepart says you don't have to use an angle meter as each flat on the bolts are 30 degrees.

Fixed it with electrical tape just wrapped it two times round the pin on the seat and rattle has gone :).

Never had a noise up to now from mine but I suppose like myself it's getting old and creaky.:D