I need to replace the front brake discs(Min thickness close to 22mm) and part no NTC8780 is not available. Can I put Disco II front disc part no SDB000380, which is available. Dico II s rears are a direct match with P38 rears. I don't want to remove the disc and take it to compare with Disco...

Thanx Marty

Some obsevation. Before starting the car, key in position II, should the TC light come ON , for bulb check? (even if the system pressure is greater than 110 PSI or not) My car's TC light is not coming when at the above position, even when I can hear the ABS pump running. Is this correct?

He says having 'ESP'. Is it true?

So far, so good., after replacing IGN relay.

Will this support the relay? https://www.ebay.com/itm/KSD-01F-Normal-Open-Closed-Auto-Reset-Temperature-Control-Switch-Thermostat/401037338276?hash=item5d5fb026a4:m:meWOoNH6wI2ALembzwiYR9A

Tried that, no improvement. Even removed the part of the inner guard towards the tyre. no luck.

In heavy traffic it warns 'gbox overheat'. I want the fan to take care of it.

It looks like what my car is fitted with. Any idea of similar type of a thermostat, after market one?

You are correct. That's why I want to have a separate relay to switch ON the fan. Can I use pin 1 wire to get the relay activated? or else I will have to add the thermostat for fan too.

It's a very simple task. No need of special tools. Read Datatech's guidance. I'm no mechanic but it was one of my first tasks with RR. Take care, I managed to blow off one of bottom supports on a front bag.:eek::eek: you know, first time errors.......:D:D

Hi all, Is the auto trans oil cooler thermostat for ' overheat 'warning message, a 'Normally Open ' type? It has two wires coming to it but RAVE shows only one. I have fitted a 7" fan and want to get a line from this to activate the relay. Your ideas welcome.

Here is a picture of the new 5 pin relay I bought from Rimmers of UK, which they said the genuine replacement for green relay of LANDROVER. My doubt is the name- the prince of darkness. Most of my 5 pins are replaced with these relays.

Yes:confused: and mostly new fuses too.:confused::confused:

The issue came back again even with a new relay already in place. While hovering through the fuse box, noted that the issue is with the relay-15, IGN relay (and not the ABS relay 17.) It too is a new relay but wriggling it, the pump came back on. Changed that too with another new relay which put...

Naocom sometimes gets into a fit. Check under instruments what is the set value for overheat warning. Mine is set at 96C and Nanocom sometimes display the warning, to see that set point has changed to 9 C or lower. Reset n everything is fine.

clue.....? o_Oo_O Really didn't have any but no alternative too. Luckily you & N2O were there to tell.

Even with Nanocom, you won't see any error codes for incorrect 'injection quantity current' value. I had it fluctuating 0-3, very low value corresponding to a higher injection fuel quantity which in turn flooded the engine and shut it down suddenly like when idling in traffic. Getting it back...

will change the relay n see.

:oops: You are correct. But the relay is new. :confused: