Sorry to hear this, location, time it was last seen and time it was "missing" would be a help.....

Axle kept in situ by a piece of old broom handle And that's it, an easy and satisfying job. There's still 'frost' on the axle! Thanks again to @rob1miles who planted the seed of the idea.....

Put the stubs in the freezer overnight And made myself a "Land Tool" (Patent Pending), there's a good heavy, hammer beating circle welded to the top

Ordered these from LR Direct Popped 2 in the oven for an hour or so at 150°, don't know what gas mark that is!

Meant to update earlier but better late than never..... Axle is held loosely in the vice to support the land from underneath. Hit with a chisel being careful to avoid the small lip at the base of the stub axle And voila, it's easy enough to prise off after that

And the LH side..... https://www.paddockspares.com/272498-eng-mounting.html

I know this says Engine but i think it might be what you're after..... https://www.paddockspares.com/engine-mounting-bracket.html

Yep, that's the answer. Steering Arm at the top is the early set-up and Steering Arm at the bottom, as mine has, is the later version. thanks Border.....

Hi all, need to replace the 'balls' on my '79 88" project. Haven't dismantled them yet so wondering do I need to order DA3169 (Early) or DA3181 (Late) and how can I tell the difference. Thanks.....

It took me a bit of effort to order too, I tried a couple of different routes. I'll check emails to see how I finally got through.

No, not flowers and stuff, trying a dry fit of a set of GB Springs and looking to repair the paint job on the clips/clasps. There was brown sticky tape securing them in transit and the paint just came away when I unpacked them. Anybody know what shade of blue they, rattlecan would be preferable...

Thanks Tot, I was watching a You Tube and he pressed it home, only by hand, but well in. I was thinking it didn't look right.....

Hi folks, fitting the Hub Oil Seal RTC3510, how far in should it go? I have it just below lip but should I press it further 'till it's against the bearing? Thanks.....

I'm hoping to go Tdi, I have all the Turbo bits and got a 300 intercooler, but this is a learning curve for me so I'll adapt as I go along. As to the winch, I'm missing the Drive Dog and the 'guide' that fits to the crossmember so I'll, no doubt, be in touch with you again.....

That's an interesting thread Steve, I'll have a further think about the GRP approach. I also have a 200 to fit so I'll read through your 'steps' over the weekend. AND I also have a winch to install.....

It looks dirty and grimy inside Lord, I haven't attempted to flush it out yet but I'll check how bad it actually is, a sealer might work.....

I like the copper idea Rob, I have an old hot water cylinder that might do the trick. I'll do a sample patch and see how it goes. Maybe get the holes near the drain brazed.....

Yep, it's a couple of pin holes near the drain and the other 'uglier' ones to the back. I'll give it a good wire brushing to make sure I've located all the bad spots.....

Yep, mine's 88" too. I was reading across a number of 'forums' that some tanks are a nightmare to fit. So Britpart are to be avoided, I'll steer clear of them. Thanks.....