As far as I can tell these are the only people currently doing anything for D2 inner wings.

Caster corrected arms would be best if you can afford it. If you lift it that much you will also need to replace the panhard rod with an adjustable one as the original will be too short and pull the axle slightly to one side. Bending the standard arms will also have the effect of essentially...

I did end up biting the bullet and buying a 2nd hand pair. If I need to replace them in future I'll be reverting to pre-facelift headlights or mounting an off the shelf round headlight inside the case.

Cheers.

Complete build thread here.

Thought I'd update this thread with a bit of info for anyone interested. It can be done but it breaks things. Having managed to prise apart a knackered unit I can see from how things are assembled inside that it was never meant to be taken apart again. The levelling motor was completely...

And just like that, they went on. Tried again this morning and they both went on without a fight. Amazing what a good nights sleep and a calm demeanour can do.

I'd rule out the XY switch. The car won't crank if this is playing up.

I kept all the clips and they are now correctly fitted to the plastic trim. I've given up for today. I'll get back on it tomorrow with a refreshed temper.

Just like that. Looks easy. I've been doing this and it's just not seating.

I wouldn't have believed these could be fitted by mere mortals if I hadn't taken them off myself. Is there some technique to it? I can get them so they look like they're in the right place but you can't see the clips and I've been struggling for an hour or so to try and get them to snap in. I've...

The fitting kit I bought has the O rings as well. My build is extremely non-standard and I've made brackets to suit front sensors on the rear.

Thanks people. I've ordered a new pair of front hubs as the rear sensors come with far too short a lead for my lift. Have also ordered a complete new set of bolts to fit them with as I used the old ones when I last changed them. Hopefully this will put me much closer to getting that MOT. Only a...

Thanks for the info sierrafery. So this morning I've done the following so far: Cleared codes. Unplugged RR sensor. Read codes again and got "RR sensor electrical failure" and "RR sensor output too low". Cleared codes. Plugged sensor back in. Read inputs: RR sensor voltage 2.17V. All the others...

Looks like your floor has suffered in the same areas as mine. I just cleaned and dried my carpet and put it back as was when it was all repaired. I'll just keep an eye on it.

You've posted the same picture twice. Did you mean to put another picture up? Would like to see some more, it looks cool.

I'm not sure what you mean by "living area". The cab or the flat bed?

I've slowly been tackling niggling problems with my project Disco and I'm down to ONE fault code. 24-08 "Rear right wheel sensor output too low" according to Nanocom. A bit of history: Fitted brand new hubs to rear axle as part of the build. Replaced standard cables supplied with the hubs for...

You mean on the back of the cab?

I'm still pondering where to put the spare. It would help if I actually had one.