Any chance you could scan it and share it. It'll only take a few days.:D

Hi. Good job on the wheels. I've currently got alloys but will be reverting to steel wheels soon as they look the biz.

Good effort. I had something similar (but not as good) in a previous 110. I will definitely use your design for my current vehicle. Thanks for the photos.

I know Adwest PAS boxes leak. I've read many post on leaks from the sector shaft lower oil seal. However my box is leaks (more like seeps) from the adjuster cap at the end of the input shaft. There is a hex shaped cap with a locking ring. When the engine is running the fluid weeps out from...

Well, today I have replaced the UJs on the steering shaft in an effort to get the front wheel to point roughly in the same direction and at the same time as I turn the steering wheel. There was a slight improvement. The drop arm ball joint is next. Then I may get to experience that famous...

I had similar intermittent starting problems. I gave the starting relay a little wiggle and it would start ok. I have a new relay on order.

Just a quick update. I've just driven 60 miles today (rural, urban and motorway) with the new transfer box and it was spot on. No sign of the previous problem at all. Mind you, it was an intermittent fault so I'll be happier still after 600 miles ;) Cheers.

There are many anti-theft devices available. Steering wheel locks are highly visible through the windows and provides an immediate deterrent. After all, for every LR with a steering lock there are ten without one. But my issue with these physical barriers is that they all have a weak point - the...

This weekend I replaced the fooked tranny box on the 110 300tdi. Removed the floor panels, transmission tunnel and the panel under the cubby box. Did 90% of the work from inside the cab.

Removed transfer box from my 110 300tdi. Eagerly awaiting the replacement from Ashcrofts.

Box of bits from Bearmach arrived today ready for the LT230 due next week from Ashcroft. Also bought a new torque wrench. :)

Have a look at this place: https://www.slip-not.co.uk They do all types of rubber matting, even some specifically for vans. Not too expensive either.

Stronger pins are an definite but the ATB is pushing my budget a little too far. There are lots of other jobs to be done on the Landy (bodywork, paint, interior etc) and a ATB would be an indulgence. But thanks for the advice though.

I'm looking at Ashcrofts now. I don't have the time, tools or (more importantly) the skills to strip a box down and rebuild it :(. May even go for a ratio upgrade so my ears don't bleed on the motorway :)

Agree, it's not moving until it's sorted.

Thanks Tottot, I do accept the blame for mincing the centre diff in the first place. I assumed that because the power to the rear propshaft didn't go through the diff that it would not cause any further damage :(. I kind of thought that it would need a new t/box but was also hoping I could get...

Hi, I recently had a recon R380 g/box and LT230 t/box fitted to my 1997 Defender 110 300tdi. Since then I have travelled less than 500 miles. However, due to a rear drive flange failure (and my ignorance), I managed to seize the centre diff. So I am now running without a front prop. A couple...

Thanks for the welcomes. I'll post some photos of my current vehicle over the weekend. The earlier ones were stored on a hard drive that went kaput. So they're gone for good. ☹

Hi, I'm a new member to Landy Zone but I must admit to plundering the troubleshooters in the past. There are some very knowledgeable people out there. I now own my fourth Land Rover (1997 110 CSW 300tdi). I started with a 1975 109 Series 3 followed by 1985 One Ten CSW Petrol and a 198? One Ten...