I am hoping someone would have a great answer to this issue, these tabs are just rubbish, what were LR thinking of when designing the tank.

My Pump is leaking from the bolt so what to get new items (part 9, 8 , 7 , 6, 5)

Hi, So, following filling up yesterday I noted diesel leaking onto the floor... it turned out to be diesel coming out of the fuel sender meeting the tank. I took it all apart, cleaned each surface and refit it but the tabs on the tank that hold the fixing plate on just bend up... poor design...

Hi, Would anyone know the part Nos for items, 9 - 8 - 7- 6 - 5 please.

Sound like a plan... ie see if it needs a little on the snail, poss a half a turn ??. Will have a got tomorrow, fingers crossed.

Well, why the rear wheels where on the stands i spin them and done up the snails until they started to grabbed than backed off just slightly. Would this be correct ?

Hi, Yep great news, moving the springs over to the storks and the peddle and hard again... brakes are back !!!! :). Next issue, took it out for a drive and it brakes to the right, just hoping it needs a little more bleeding. But thanks guys for your support and help on the matter.

Hi Guys, So good news bad news.... thanks @zeaphod yep clamped the rear flexi hose and the brake pedal was hard... undo it and again the pedal went to the floor. So good news it the rear brakes, dam spent £50 on a new master cylinder :( . So I have attached a photo of the rear brake shoes... I...

Hi All, Thanks for the info... have ordered a suction vac unit to assist also. Once it here this week will have a go at your suggestions and report back.

Hi, the shoes came off... putting back on i believe they were still closed. I do remember that to get the top spring back on I had to use pliers on the end of the spring to pull the shoe over. I just can't see what i done to have this issue... any help you can give would be much appreciated.

Hi, Need some urgent help guys.... So 3 weeks back I parked up my Defender and went about replacing my rear stub hubs and bearings. And to do this took off the drum braking assemble in one go and hanged these up on the springs to save touching the braking lines and draining down the system, it...

Thanks.... this is a great help :)

Hi, Would anyone have a PDF copy of the noted workshop manual that they don't mind emailing me? It would be much appreciated.

Definitely food for thought..!!! Thanks for the advice....

Thanks "Frostythor", this is a great PDF parts drawing... do you know were i can get a full copy of the manual? This would be very helpfully to have and assist on work that i need to do on the 90.

My rear axle to my 90 Defender, K reg is 22S 13141B…. replacing my bearings I noted that when removing the old bearings an outer oil seal was installed (No 12). But looking at the LR Workshop manual being a 90” these are exempt. It could be that the last person to have it installed them by...

Thanks for the info so far... i need to replace both axle drive halfs as the last owner welded the end to the drive flange. Paddock own seem to sell these for the 2 pinion's, so fingers crossed its correct :)

Hi, From the stamp on the outside of the Diff ( HRC 1124 ) & ( A-15L-F ) can you tell from this if its a 2 or 4 pinion Diff ??

Hi, I can't find the serial number for the front axle (but found the rear axle)... i am not sure if the past owners have replaced it or not but need to order parts for it. Its a 1992/93 Defender 90, is there any way to find out were it sits in "Change Points" in regards to ordering parts? Is...

Hi, Can anyone tell me how you fit these brake pad springs please?