Lol!!! Should be there now......even though I’m not sure it was worth the wait for you guys or my effort which took up valuable drinking time!!!

Is that better?

CB all wired in now. I decided to check ground resistance from the antenna mount to the chassis. Got 0.3ohms Added a short wire from the mount to a bolt that fixes the roof to the side panels like so... And got the reading down to zero ohms. That’ll do for that,then! And...

Mine don’t rattle at all! In many ways I prefer them to wind up window doors. I love having the door tops off when it’s hot. The ally door tops on 90’s / 110’s are much better than the series versions. Both front and back panes open individually and the frames are ally...... Bit pricey but...

I fully agree with the above!

^^^^ same. Also Flash Lane nr Matlock used to be good. Did that one at night. Nearly poo’d myself :oops:

Or does it have the big bulky waterproof instrument binnacle? Like this....

No laughing here! Just genuine interest! Remember green laning with a bloke in a very modified V6 one years ago. It was very capable and looked the dogs danglies... Believe he was from near Manchester somewhere and wen by the name of Doobrey Dog on LRUK.... Anyway, look forward to your...

It was radius arm chassis end bushes on mine. Can of silicone spray and a straw to get it into all the little nooks and crannies sorted it out until I replaced the bushes. Do on corner at a time if you want to trace which one squeaks. Could also be shock bushes. Same treatment should do the...

And where is the hammer drawer? :D

I’d love to go to Australia too....maybe @Marmaduke can sort it for us!!

I like that a lot. Great work! :)

I reckon some louvres on the back window might work..... Maybe you could modify your disco to look something like this.... :D

It was ok. The leaks were from the intermediate shaft, front flange seal and the joint between the main housing and the front output housing. Got it finished (finally) today. Tested and so far so good! Also made a start with fitting my CB

Today I took the DISCOVERY transfer box off my 90 because it has shamed itself and peed oil out since I fitted it a couple months ago. It’s the only leak on my 90!!!:mad: Front output housing and the seals and joints on it are all replaced / remade. When I get back from the pub I will do the...

Sorry, It’s a 300tdi engine in an ex mod Ninety. I didn’t even consider cranking amps!!

Hi all, I have a lot of wiring on my Ninety that is permanently live ie not ignition switched, and whilst every circuit is fused, I got to thinking that maybe I should add some protection between the battery and the fuses... Has anyone here used these-...

I seem to remember from when I looked into this a few years ago, that the pas pump from a 200tdi is what you need. However, I think you also need the mounting brackets which, iirc, can be hard to come by. I cant remember exactly and cured it in mine by fitting a 300tdi and PAS from a rotten...

I got annoyed with mine and spat my dummy out!:mad: Been trying to sort out all my additional wiring, along with adding some for a leccy fan and also an led light bar for the roof (mahoosive and provided very kindly by Mr @Marmaduke). Ended up changing the alternator as the smoke escaped from...

Looks like a great project! Hope you can get back on with it soon!