pics

ok with some speakers inside and so far no problems with 8inch light bar between 2 of them.

I went and bought a load of these: https://www.ebay.co.uk/itm/2X-2-51mm-Bull-Bar-Roll-Cage-Mount-Bracket-Clamps-LED-Light-Bar-Holder-Offroad-/223716320296?hash=item3416882428 not from that seller though. you have to open them out a little to get around the bar but once on there's loads of...

welcome to the asylum.

Just replaced my turbo a couple of weeks ago. I did put a thread on here but search function is down so can't post a link. I had the same problem with the kinking pipe. I just fitted it at the block side first maybe 90 degrees out so when it tightened and twisted it ended up in the right place...

Just replaced my turbo a couple of weeks ago. I did put a thread on here but search function is down so can't post a link. I had the same problem with the kinking pipe. I just fitted it at the block side first maybe 90 degrees out so when it tightened and twisted it ended up in the right place...

Just replaced my turbo a couple of weeks ago. I did put a thread on here but search function is down so can't post a link. I had the same problem with the kinking pipe. I just fitted it at the block side first maybe 90 degrees out so when it tightened and twisted it ended up in the right place...

Just replaced my turbo a couple of weeks ago. I did put a thread on here but search function is down so can't post a link. I had the same problem with the kinking pipe. I just fitted it at the block side first maybe 90 degrees out so when it tightened and twisted it ended up in the right place...

these guys may have some bits you like the look of: https://www.mudstuff.co.uk

and then get the spare wheel carrier!

stable matting :) £40 a big square. took two to do the back with a lot of off cuts because it wasn't flat. Does a good job of sound deadening. give you dimples in your bum if you're sat on it for too long though :)

eventually a rear facing couple of seats over the batteries are planned

shiny, like it!

LOL I got lucky there then :) just thought it would be closest to the bulkhead so easiest to fit. :) I'm too scared I'll cook the engine or damage it some other way to go over the top with the mods. I tried a boost pin and slightly adjusting the fuel pump but ended up over fueling so backed...

Install new turbo instructions: Remove turbo assembly 1. Disconnect the battery. 2. Drain engine oil and change oil filter (fill filter with oil before refitting or take an age priming later!) 3. Slacken the clamps and remove the air trunking connecting the intercooler to the inlet...

oh yeah, and I've got the full size intercooler fitted too.

Hi BFG, I've got a line running from the inlet manfold to a pressure gauge in the cab. #10 wasn't my post - just an internet pic of something I have similar. Are you referring to the stripe lock? This is a VNT turbo. I tapped a hole in the exhaust manifold bull horn closest the bulkhead. Not...

Proof it happened: Certainly a lot more performance at lower revs now. The boost is picking up quickly and settles at 0.9 bar at 65mph. I had a 1.2 transfer box put in by Ashcroft and I'll admit it was a little bit too much, she shifted much better today (I think the 1.3 ratio they do would...

You're looking in the right place. To quote another website :https://forums.lr4x4.com/topic/24508-measuring-piston-protrusion/ You're likely to have the largest thickness I guess.

It's alive!! A few things to sort on the way: Air filter housing was wobbling around and I found the rubber mounts had torn through on 3 of them - So removed the air filter and re-fitted with some bold stand-offs (a temporary fix for a couple of years). Also found that the air intake pipe into...