Ok thanks... will look into it...

ok... had it tested underload and curiously air flow showed 0000.0 for anything just over 600+ gr/hr... Manifold turbo pressure peaked at close to 200kpa... another thing is that it showed the gearbox in DRIVE when its in P with the Transfer Ratio on LOW when its actually on High... Any...

Have not managed to test it under load yet... Hopefully will be able to get it done tomorrow or Saturday...

Haha!! Yes... the fuel guy... They said they've not done this model before so needs to fabricate the mount and cam in order to test the injectors... My mechanic sent the car there over two weeks ago but the fuel guy have not managed to get the mount or cam done so the car was taken out for the...

Finally managed to plug in the nanocom today and only 1 fault code after clearing the old fault codes... 03-07 air flow circuit (intermit.) Some of the readings during idle are as below: Engine Speed (RPM) - 755 Idle Speed Error (rpm) - -1 Road Speed - 0 Battery (v) - 13.248 Accel. Way 1 (v) -...

Mass Air Flow...

Well... the car is now with the fuel pump guys checking the pump and injectors... Still waiting for the verdict as apparently they had to engineer a mounting for the injectors to test them as they don't have one that fits... hoping like hell that this IS the problem and I can have it back by...

Hi PaulTD5, my mechanic is now taking out the fuel pump and filter to see if they're clogged as the car did almost run dry the other day... further more... mine struggled to reach 100kmh (60mph?) on the flat... have ordered a Nanocom and hopefully we'll have a clearer picture once I get my oily...

must take a look underneath...

Do all Disco2 TD5 have cats? Cos I read somewhere that none is fitted....

Called Bearmach and Difflock but they both don't have Nanocom in stock... Bearmach did mentioned that they do have HAwkeye... Is it any good? Can't seem to find any info/comment in the forum...

I think the last owner put a curse on it...

Tested the car today on a steep slope... it's ok when its moving but its a different story when it's stopped on the slope... Even with pedal to the metal, the engine barely responded... The car will actually roll back 5 to 10 feet before it starts creeping forward ever so slowly until it...

Thanks Dave... Will contact them for quotes....

Thanks for the feedback... Will definately consider the Nanocom... where will I be able to get it? As for the M&S light... it did light up a few months back but I couldn't remember if they were flashing thou (any difference?)... the car can get up to 100Km/h and changes gear thou...

Cylinders had grooves in them when we opened it up... Overhauled the engine and now response is much better... when on the move... Standing start is still hopeless and downright hazardous as the acceleration from 0 is terrible... Any suggestions??

is it the bit between the rocker shaft and camshaft carrier?

confirmed xyz switch... have asked mechanic to move the A/C drain pipe while he's fixing the box... Why the name "XYZ" anyway?

ok will check... Thanks...

Correction... have access to "Launch" and code says 'Vehicle Speed Outside bounds for cruise (Where Fitted) Active'..... Any idea what that means?