Did you know you can solder the crimp connectors shown in your picture. I do at times, two ways to do it. 1..............Push more wire than need past the crimping section, crimp it down then solder the extra wire on the triminal 2..............Cut off the blue/red plastic bit then solder. Any...

What engine? mate of mine said that TD5 burn out the starters, another mate of mine with a TD5 went through two in 6mths! Check your earths, most faults are bad earths! not live. You could check it by running a switch live down to the spade terminal after d.i sconnecting the one already there.

Do you mean the alloy casting that the oil filter fits to? Which on the 200TDi and my old TD also have the oil cooler pipes and the pressure switch. If so the that held by two 17mm bolts (think thats the size). Undo them take of the casting clean stick a new gasket on. Job done. When i...

Or buy a 90 thats had a 200TDi/300TDi conversion but make sure its been done right. On the water leak side you can waterproof them! Mine don't leak through the roof never has but if its got a van back with no full headlining trim then you will get condension. Most people as suffer from poor...

Thanks guys just what i needed to know. boydy1989 Re your offer thanks but no I think i have found one near me. cheers anyway.

Why??

Ok I need a replacement door for the 90. Its got the original van back and door, so will a Series 3 door fit? I know that the Series is a 2 hinge and the 90 a 3 but that a simple drill job but will it fit the 90 any one know???

Oil lines, Use the 200TDi Rad and Cooler, then the Oil lines from the TD will fit. Mine did! By using the TD Oil filter housing and oil lines then it all reached. Did not need to cut and shut anything here. Running Disco1 200TDi/LT77 gearbox. But did change over the flywheel housing for the...

Sorry to here this. We had a customer have theirs nicked, found bits on ebay. So if you can tell any bits check out ebay just in case. I fear it may be broken and sold as parts.:mad:

Thanks guys for the tips. Coke sounds good will remember that one. boydy1989 was right the heads already off! Decided that 4llb lump hammer and punch will do the trick(after finding that some of the internal parts of the injector had gone missing, now i know i put them safe somwhere) So...

Hi,new guy here from Dorset/Wiltshire. Testing images

Hi, thanks. Thats what i did with 3 of them but no:2 just will not move. In fact the dam thing unscrewed itself and now I have a pile of springs and what look like shims. I was wondering if it was luck that 3 came out or was a service tool ment to be used.:(

Hi, newby here. Been looking around the site for a while but now i need some help so signed on the line, hope you guys can help. Got me a 90 with Disco 200 engine, did the conversion early part of this year, but me head gasket has gone. Now i have got the head of but can see that the...