N

Norton643

Member

• Today at 19:04

• #1

Just going to change my rear wheel bearings. I am confused on the torque of the large driveshaft hub nut. It says 330N/M.... plus 1/3 turn.? Is this correct as thats around 243 foot pound ...plus 1/3 turn? Seems a hell of a lot.

 

F

FrINlander

Member

• Today at 19:10

• #2

It's a sh*ton, that's why the forum is full of posts about how hard they are to get off. I just tighten them down until I can't, they've stayed on(for now).

 

Freddie17

Can’t reMember

Full Member

• Today at 19:10

• #3

Assuming all model years are the same (I believe they are), the rear driveshaft nuts on an F2 are 395Nm, or 291 lbf-ft.
And you should use a new nut

You still need a big torque wrench.