I done some polishing on my floating caravan.........& I have a galaxy A16 stupid phone.

It's a bungalow and I always leave the living room stat fully open because that's where the controller is. I keep hall, bedroom and bathroom at a medium heat and living room an kitchen nice and cosy. All pipes go into the attic and drop down into...

Orizontal bits get hit wiv more sunshine. So more potentual sun damage.

Gardener.

Just spray it with water, if it looks fine then, it's the lacquer/clear coat.

W has just spent time polishing up some dirty silver jewellery that she got from an auction. Just discovered that a kilt pin she bought for £40 is for sale on Etsy for €138.7! Have to admit she is very good at this!

Yerbut what @Stone56 was getting at, even the lowest forms of life dunt want a Freelander :p

On my Disco 2, the laquer coat has peeled off massively on the roof. Where I doubt anyone has put any polish on, far too hard to get to. 😜

Funny. Especially when posted in the section that lists freds such as: Rear cross memba rust. Wots the best replacement shassy supplier. MOT man poked oles in me shassy. Sellin the heap as it wunt pass the next MOT and eye int got time ferra rebuild.

Does yer pinch the seeds offit before the burds get them, to grow more sun flours?

My 15mm pipe bender doesn't do tight bends, only similar to the one in the picture that's why I thought 10mm pipe would be better, My brake pipe bender does 10mm so pipe should be hidden under the radiator, I'll paint the exposed pipe to match...

Magpies? We have some squizzles near work that are plagued by maggies sometimes ...

Not sure what that valve is there for, temp fitting? while work being done? Personally I would just take it back to the trunking and go from there neatly with 15mm. but then I have a nice pipe bender that could get from the trunking to the rad...

Searched all of the house, all garments, both cars and a lot of outside. Still couldn't find the key to the polytunnel. So had to take the padlock off with bolt cutters. As everyone knows, we'll find it by buying a new padlock. Cool here...

I finished the plastering because it wasn't straight Plumber and joiner fitted skirting and radiator on same morning working together I've since replaced the architrave and now replacing skirting and tidying plumbing up

I'm well cheers. I just don't post very often but I do pop by fairly regularly 😀

Plasterer or plumber?

This is the wonderfull job workmen did after plastering the walls 🤔

Your right I spose I don't like compression joints on show so rather than solder a bend in I was thinking I can get a tighter bend in the micropipe so it looks neater. I also have a part roll of micro pipe in the shed and the rad needs a new...

Saw that on tinter web, but "er indoors wouldn't let me go :rolleyes:

Have you got day tickets to Swingerfest?

Tidied part of me garage this morning to a (very) basic standard and binned some junk. Emptied my box of assorted drill bits yesterday and binned most of them (why I kept knackered bits I don't know). Got under me tratter bonnet this morning and...

Or cut shortern in the pipe trunking make them both run above the skirting in a neat manner and lift the Rad brackets a few inchs higher. Or just remake the 1 that used to run along the wall from inside the trunking. or just the last bit from the...

Morning all, I might get some welding done later. Off to polish a bit of my boat I may be back sooner if it starts to rain (very dull n overcast) njoy yer day zooners.

Problem is more than visual Old skirting was only 2" high and one pipe ran above and one along the wood Pipes need to be bended outwards to clear the skirting as they don't (and never have) sit nicely on the wall as they come down So either bend...

Morning All. :D Cat's unwell, has a little diarrhoea problem. :( Usually cats manage to sort themselves out and their gut is very robust, but if she is still unwell by Monday its the Vet's. No thunderstorms and just light rain here (yellow...

Might be, I don't know. I may give it a good MER polish on the bonnet. :cool:

There's a sqworkin squirrel on me garage going bonkers at worr eye fort was anuvva squirrel who wants to share brekfust nuts. He's bin going fer 5 mins despite me looking out so eye gorrup and went out the front to look down the side ov me...

However, I do think Dacia have got it right with that Spring fing of theirs. Small, cheap, reasonable miles. Most other leccy cars are monstrous great things with too many doohickies to drain the battery. Like they say K I S S.

TBH I wouldnt bother, fresh coat of paint on the pipes. Whos gonna see/know/care? (the answer is not you) If you really want them to run on top of the skirting they will be more visible even if smaller pipe. Yes there will be extra resitance to...