What finish are you after kiddo? Colour matched or just nicely finished 🤔😊

Thanks Keith. Height sensors seem ok with RSW software plugged in. Just been looking at when you repaired a driver pack, daja vu or what

Past 2 weeks back end sagging overnight. Leaks found in bags so they were replaced. Back end still going down. Diaphragm valve was leaking in valve block so decided on full rebuild. Was given a valve block to rebuild with full kit from XR8. This...

Could also be a height sensor. Driver packs can be fixed so if you replace it do not bin the old one.

A regular issue for a land rover 🫣

Indicators overriding the hazards seems a good idea to me. Imagine being on tow, hazards on to warn traffic behind but still being able to indicate the intention to turn.

Ooh, I'd be pulling the head to check and gauge it from there, I don't suppose you have a picture of the marks do you 🫣

There should be no extension from the loom to the sensor. It could be that the wires are crossed or shorted inside the tape. I would get the connector and a decent length of wire off a scrapper, solder it to your loom and insulate with glue...

My indicators over ride my hazard lights

Had the hose and extension lead out for mixing cement, when I finished that job, as the sun is shining today I jet washed the mud & mold off both P38's. They are not clean, just a good deal less dirty.

Yep you also have issues :)

I will check again later

I checked mine again and it does override the hazards. MY2005.

Speak for yourself..............at least today anyway, who knows what tomorrow will bring :)

So are our landies!

I don't. But I'd go with what the manufacturer recommends.... Is this the right instruction sheet for your kit? I think it is. https://tech.arp-bolts.com/instructions/157-4301.pdf You can convert freedom units to proper money here...

I'd be stripping that dodgy red stuff of that plug in your previous picture🤔

We are all a bit broken lads🤣

what if i have both!?

Oh I definately have issues :)

We have tried to order height sensors from Island 4x4 multiple times with no luck. Either they just dont respond or they respond with no stock. Because of this we are busy developing a mod that will allow you to fit magnetic potentiometers that...

Ooh, Interested 🤨

One of you two has issues 🤣🤣 oh and a problem with your car🤔🤭

I can officially say that the indicators don't override the hazard warning switch. They still all flash regardless

I love snow. The proper stuff that we rarely get anymore in England (when we do there's an enforced lockdown and all the roads are closed) but i love the hot sun too. All we ever seen to get is cold and damp out slightly warmer and damp. Or 'too...

Yes managed to fix it , it was the rear boot seal had become unhooked

It'll be the leaking panel gaps and sealing that does that😕

There you go matey, it's coming 😀

We had 4 days of sunny weather a week ago, got up to 17C one day. I guess that was spring. Just long enough for me to cast a new concrete top for the fosse septique and a new regard before inspection on Friday.

Personally, I'm not inclined to use second hand. Eurospares should be OK.