For anyone who cares, this is how i split the ball joint

It's in RAVE.

Ratchet ring spanner perhaps? Sometimes helps to press down where the hinge is after removing the nut to take the tension off the wiper and allow it to wiggle off the spindle.

From quite a number of hours of research on the proshaft phasing topic: In phase being where the u joints line up with each other like the rear driveshaft does. -All genuine LR front driveshafts for the P38 have the u joints set slightly out of...

I was still in school 😂

That's OK for changing the blade, not sure it helps for removing the arm though.

there is a fue There is a fuel heater in the top of the fuel filter, the temperature sensor is, I think, part of the FIP

Or you just pull.. if it's been out enough times 🙄

2 jigsaw blades release the head unit.

Finally got round to doing this job, you were right it was very awkward, looking at RAVE its a 20 minute job which isnt the case! Even with the wheel arch liner removed it was still a pain but doable!!! I only had one hose so my P38 is obviously...

Operate the wiper and in mid swing open the boot lid it that helps? The wiper will stop instantly in its position when the button is pressed on the boot👍

I don't suppose you've got a couple of pictures have you my good man. There may be some sacrifice to be had.. 🤯

Sorry I've misunderstood, what is exactly suck that long bolt or the ball joint nut?

Does the bolt move? Get in there with a grinder or a reciprocating saw. Pull the arm out completely and then renew the bits your focused on. 👍

Bah. Aftermarket rubbish!

If the bolt won't come out as you expect you mave to.. A, drop the fame, B, cut the bolt after checking it can be put back in from the other side👍

I know what your saying. My sons does have a vibration at around 70 so what I might do is drop the prop and see if it can be changed to phased or not. It may not be possible but I'll find out. 😊👍

Is the ball joint ruined already? If so, then a ball joint fork can force it out at the cost of the rubber boot🤔

Two switches?? 🤯

The brake switch controls the circuit for the brake lights and the circuit for the cruise control if fitted 🤔 but the abs I'm not so sure about...

Switch still not correctly adjusted maybe.

The brake light switch doesn't cause the abs+tc lights, but low pressure will. Ignition off. Pump the pedal 5 times. Ignition on but don't start the engine, you should hear the pump buzz a few seconds then stop. Count how many times you pump the...

Crows foot in the correct position or just effing tight. You feel it go when it's too late😜

Had some of that, don't like the Klene Prep for clearing everything out but the lady consultant is rather nice. Bonne chance.

I'm in Mexborough hospital Wednesday for the camera into bowels. Yuk 😁

OK, cat among the pigeons... My 99my front prop is straight with matching positions on the uj's. My son's 2000my front prop is phased🤯

I just Mark them up and tighten back to that spot👍 Check the surface and check for play, I've seen two 2000my with failed bearings in the nose🤯

You'll get sacked for being late lad😜