Slow…. But have a few friends checking some routes/lanes next week.
Gave a few locations for them to check while they are in wales.
Need to hop on the Motobike & spot some lanes. Been doing too much driving,even last weekend with no time to sit...
I wouldn't change anything just for the sake of it. A 20 year old Genuine hose is probably better than a new Britpart one, same with the water pump.
Mind you water pump isn't original, what make did they fit last time?
Busy day…
Removed the tunnel to get a lot of work done easily. Hi/low lever not holding low correctly so rotated a collar a bit(road test later)
Easy gear box oil acsess(top up)
Grease prop shafts from above
Remove middle seat panel for the...
Ridgeway 4x4 Swindon. That is just 1 of the rooms.
I can wander in there & get parts without chassis numbers. If it’s not on the shelf it’s normally next working day(if urgent)
Does stuff on line as well,both new and take off items.
Has a...
Changed the ABS shuttle valve today. Absolutely hate doing this job, wouldnt be so bad if it was easyto get my wings off 🙈
Through the hole it is! Took about 3 hours and some cut wrists
Finally out and replaced with a pre modified one which...
Time to check everything lines up! Also repaired the pillar and neatened it right up. I’m going to chop the bottom off other side and repeat the process as it’s so much tidier and I hate it when this area looks scabby. You really notice it on...
Hello. Glacial progress continues. Might as well show you what little there is.
Primer went on with brush and roller. So did the top coat.
The finish is ok. I know a lot of people get fantastic results with brush and roller but I don't. To...
Hi. When it clicks and works the dash light's up. But when its not working the relay clicks, but the dash does not light up.
I'm sure I have the wipac relay fitted already, need to check as it's been a while.
leds do not drawn enough current for a bi-mettalic spring to work ( old school relay) they use a chip controlled circuit with tunable load balancing thus it will click but may not switch......or just need tuning hence the knob on the top
Yes it also has the flanges too as the intention for it was to go on a TD5 110, but that never materialised
So hopefully if it fits speedo works etc am definitely having it for my 300 Tdi 90