yellowlandyman
New Member
My 110 Hi-Cap 300 TDI conversion landy keeps over heating.... I have seen a lot of similar threads and have already followed much of the advice but I'm still garaged and summer's coming.
Before you ask. The power and heater are working great! Water is flowing into the expansion tank and I have replaced the following;
This is the agro section.
If take out the Thermostat the truck stays around 40 - 80 at load and the radiator is evenly hot all over. But as soon as I put the Thermostat back in the temp goes up to 100 and the rad is cold, and so is the top hose.
As soon as I pump it (the top hose) a few times it heats up along with the rad but quickly cools down until I pump it again but the engines stays hot.
I take out the Thermostat and again no problems, I have tested it (the thermostat) and it works. I have also tried every method listed to bleed it. What's up!!
..
Before you ask. The power and heater are working great! Water is flowing into the expansion tank and I have replaced the following;
- Pump
- Hoses
- Expansion tank cap
- Thermostat x3 times including genuine land rover
- Radiator (bearmach)
- Temp Gauge and Sender
- Viscous Fan with Electric Fan
This is the agro section.
If take out the Thermostat the truck stays around 40 - 80 at load and the radiator is evenly hot all over. But as soon as I put the Thermostat back in the temp goes up to 100 and the rad is cold, and so is the top hose.
As soon as I pump it (the top hose) a few times it heats up along with the rad but quickly cools down until I pump it again but the engines stays hot.
I take out the Thermostat and again no problems, I have tested it (the thermostat) and it works. I have also tried every method listed to bleed it. What's up!!
..